BLADE GP-MULTIPURPOSE BUCKET 2795385 - Caterpillar

Illustration 1 g00101627
The drain valve for the engine crankcase oil is located under the rear of the upper structure.Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on Containing Fluid Spillage.
Illustration 2 g00937651
Open the crankcase drain valve. Allow the oil to drain into a suitable container.Note: Discard any drained fluids according to local regulations.
Close the drain valve.
Open the engine hood.
Illustration 3 g00686495
(1) Drain valve (2) Engine oil filter
Open drain valve (1). The drain valve is located on the bottom of engine oil filter (2). Allow the remaining oil in the filter to drain into a suitable container.
Close drain valve (1). Tighten the locknut to 40 5 N m (30 4 lb ft).
Remove oil filter (2). See Operation and Maintenance Manual, "Oil Filter - Inspect". Discard the used oil filter properly.
Clean the filter housing base. Make sure that all of the former filter gasket is removed.
Apply a thin coat of engine oil to the gasket of the new filter.
Install the new filter by hand. When the gasket contacts the filter base, turn the filter by 3/4 of a turn more. This will tighten the filter sufficiently.
Illustration 4 g00937661
(3) Dipstick (4) Oil filler plug
Remove oil filler plug (4). Fill the crankcase with new oil. See Operation and Maintenance Manual, "Capacities (Refill)" and Operation and Maintenance Manual, "Lubricant Viscosities". Clean the oil filler plug and install the oil filler plug.
Do not under fill or overfill engine crankcase with oil. Either condition can cause engine damage.
Start the engine and allow the oil to warm. Check the engine for leaks. Stop the engine.
Illustration 5 g00104116
Wait for 30 minutes in order to allow the oil to drain back into the crankcase. Check the oil level with dipstick (3). Maintain the oil between the "H" and "L" marks on the dipstick. If necessary, add oil.
Close the engine hood.