BLADE AS-UNIVERSAL 3853443 - Caterpillar

To prevent personal injury or equipment damage from failure of the flow meter or associated circuit components because of blocked pump flow, make sure before starting the engine that the flow meter valve (K) is fully open (turned couterclockwise).
Preparation
Position the machine on level ground. Turn the key start switch to the OFF position in order to stop the engine.
Release the pressure in the hydraulic system. Refer to Testing and Adjusting, "Hydraulic System Pressure - Release" .
Locate the auxiliary hydraulic lines at the end of the stick and at the connection to the attachment tool. Remove the covers and the flanges from the elbows. Set the covers and the flanges aside.
Install the portable hydraulic tester (31) between the auxiliary hydraulic lines at the elbows or the valves. Refer to the illustration of the flow meter tool layout. Open the valves in the auxiliary hydraulic lines on the stick.
Turn the key start switch to the ON position in order to start the engine. Place the power mode selector switch in the Power Mode position. The indicator should become ON .
Place the engine speed dial in position "10" on the indicator. Push the AEC switch to the OFF position. Maintain the engine at 2050 50 RPM. Three seconds after the engine is started read the engine speed.
Increase the hydraulic oil temperature to 55° 5°C (131° 9°F) .
Select the desired engine speed setting in the programming mode.Note: For more information on programming, refer to System Operation, "Auxiliary Control (Pump Flow)" .
Illustration 2 g00335838
(17) Display (18) "ADVANCE" key (19) "ENTER" key (20) "+" key (21) "-" key
Use "ADVANCE" key (18) in order to select the setting for the flow.
Monitor the flow rate at the hydraulic tester (31) . Use the auxiliary controller to increase or decrease the setting of the flow. Change the setting of the flow at the auxiliary hydraulic controller until the desired flow rate is obtained.
Illustration 3 g00294828
Right console (1) Attachment switch.
Illustration 4 g00294827
(2) Ball valve (A) Single action (B) Double action
To prevent personal injury or equipment damage from excessive or insufficient flow rate, always use the "Attachment Tool manufacturer's specifications" for appropriate flow rate settings.
Repeat Steps 8 to 12 for other work modes. Only the settings of the current work mode may be altered. Change ball valve (2) and change the attachment switch to the appropriate position in order to change the settings for other work modes.
When all the settings that need to be changed are complete, save the new settings. Save the settings by pushing "ENTER" key (19) , and then push "+" key (20) .
Turn the key start switch to the OFF position in order to stop the engine.
Close the valves in the auxiliary hydraulic lines that are on the stick. Disconnect the portable hydraulic tester. Replace the flanges and replace the seals to the auxiliary hydraulic lines. Replace the blocking plates if the auxiliary hydraulic lines are equipped.