BLADE GP-STRAIGHT 4T9585 - Caterpillar

order to enter Harness Code Mode (Mode 5), hold down the "CLEAR/MODE" switch until "-5-" appears in the Display Area. When the Display Area is in Harness Code Mode, the engine code is shown on the Display Area. The engine code must correspond to the engine sales model. The engine code is a two-digit representation of the harness code input.Note: Harness Code Mode 5 is only available on 155-8653 Engine Monitoring Control (Caterpillar Monitoring Systems) and newer Caterpillar Monitoring System modules.
Table 1
Mode 5 Harness Code Display     Application    
03     Generator Engine (1) with Standby Panel    
05     Generator Engine (1) With Prime Panel    
06     Generator Engine (1) With Premium Panel And "SCAC"    
07     Generator Engine With Premium Panel And JWAC "JWAC"    
09     Marine Propulsion Engine With Premium Panel And "SCAC"    
10     Marine Propulsion Engine With Prime Panel And Marine Gear Sensors    
11     Marine Propulsion Engine With Prime Panel And No Marine Gear Sensors    
12     Marine Propulsion Engine With Premium Panel And "JWAC"    
35     Locomotive Engine    
( 1 ) Includes Marine AuxiliaryNote: If the selection for the harness code does not match the application, the Caterpillar Monitoring System may not operate correctly. The following list contains problems that the operator may encounter: the loss of event notification, incorrect data displays, incorrect gauge needle position and incorrect activation of diagnostic codes. CID 127 FMI 08, CID 177 FMI 08 and CID 819 FMI 02 are commonly caused by harness codes that are not correct for the application on new installations. Troubleshooting procedures are given for these diagnostic codes in the Testing And Adjusting Section of this Manual.An example of Harness Code Mode (Mode 5) is provided below.
Illustration 1 g00533697
Display Area