AVSPARE.COM
parts catalog

BLADE & EDGE 4Z9363 - Caterpillar



4Z9363 BLADE & EDGE Caterpillar parts BLADE
Rating:
11
Alternative (cross code) number:
CA4Z9363
4Z-9363
4Z9363
Caterpillar 4Z9363 BLADE & EDGE
Weight: 0.010 pounds 0 kg.

Buy BLADE & EDGE 4Z9363 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 12 g01330503
Typical example
Use Tooling (D), Tooling (H), and a suitable lifting device in order to turn over suspension frame (5). The weight of suspension frame (5) is approximately 247 kg (545 lb).
Illustration 13 g01327745
Use Tooling (B) in order to install spherical bearing (13) into suspension frame (5). Note: Ensure that the tapered sleeve that is on spherical bearing (13) is installed in the correct orientation.
Do not prime the top cavity of spherical bearing (13).
Illustration 14 g01327744
Illustration 15 g03876195
Ensure that the tapered pin is clean, dry, and free from grease. Ensure that there are no burrs or damage to the tapered pin. Install bearing seal (12) onto the tapered pin facing the rear right side of the machine
Illustration 16 g01330505
Use Tooling (D), Tooling (H), and a suitable lifting device in order to turn over suspension frame (5). The weight of suspension frame (5) is approximately 247 kg (545 lb).
Illustration 17 g01327566
Use Tooling (C) and Tooling (D) in order to install front suspension frame (5).
Illustration 18 g01327672
Position washer (11) onto the tapered pin and install bolts (10).
Tighten bolts (10) to a torque of 135 25 N m (100 18 lb ft) by using equal increments. Use a suitable hammer in order to strike washer (11). Do not strike the bearing or outer race or frame. Tighten bolts (10) again to a torque of 135 25 N m (100 18 lb ft). Repeat tightening bolts (10) until no loss of torque is evident.
Illustration 19 g01327660
Prime the cavity in the center of retaining collar (9) with Tooling (F). Apply Tooling (G) to the mating faces of retaining collar (9) and the suspension frame. Position retaining collar (9) and install bolts (8).
Illustration 20 g01327625
Illustration 21 g01327646
Use two people in order to position bracket (7). The weight of bracket (7) is approximately 35 kg (77 lb). Install bolts (6). Tighten bolts (6) to a torque of 800 100 N m (590 75 lb ft).
Illustration 22 g01327597
Install bolts (3) in order to connect bracket (4). Repeat this Step for the opposite side.
Illustration 23 g01327594
Install clip (2). Connect grease hose assembly (1).
Remove the suitable blocking.
Recheck the torque of bolts (10) after road test. End By:
Install the stabilizer rod for the front axle.


Parts blade Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.