BLOCK-ADAPTER 1U9767 - Caterpillar

Illustration 1 g06341094
(1) 567-2388 Lock As
(A) Former handle assembly
(B) New handle assembly
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.
Lock Replacement
The following procedure is for replacing 567-2388 Lock As.
Illustration 2 g06341100
(2) Plate
(3) E-ring
(4) Cylinder
Remove E-ring (3), plate (2), and cylinder (4).
Install new cylinder, plate, and E-ring.Note: E-ring must be installed using an E-ring pliers to prevent deforming the E-ring.Accessing Handle Assembly for Replacement
If a door cannot be opened using the key, access the rod inside the door and pull downward to open the door.Pump Compartment Door
Illustration 3 g06341103
Machine right-hand side rear door
Remove the bottom plate and access the rod from underneath the machine.Battery Compartment Door
Illustration 4 g06341108
Machine left-hand side front door
Open the rear cab door to access the rod.Radiator Compartment Door
Illustration 5 g06341112
Machine left-hand side rear door
Open the battery compartment door to access the rod.