BLOCK GP-LONG 20R2696 - Caterpillar

In some applications, such as connecting rod bushing installation, temperatures higher than 170°C (338°F) are needed. To by-pass the temperature detector in these applications, the detector must not be connected to the part that is to be heated. The part can then be heated but some other method will have to be used to control the temperature to which the part is heated. One method is the use of temperature sticks. These sticks are used to put a mark on the parts. The mark will melt when the part gets to the desired temperature.
Illustration 1. 6V6996 or 6V7118 Induction Bearing Heater.After it has been determined how long it takes to heat a specific part to the desired temperature, a timer can be used with the heater. A timer, that will shut off the heater at a desired time, is also available from the supplier of the heater.
The temperature detectors, and timers are available from:
Jergens, Inc.
19520 Nottingham Road
Cleveland, OH 44110
U.S.A.
Phone: (216) 486-2100
TOBA, Inc.
12-23, 4-CHOME, GINZA, CHUO-KU
Tokyo, 104, Japan
Phone: (03) 541-3961-5
Cable: TOBAYOOKOO, Tokyo
Telex: J27796, TOBAINC
Three suppliers of temperature sticks are:
Markal Company
250 N. Washtenaw Ave.
Chicago, Il 60612
U.S.A.
Phone: (312) 826-1700
Safety Direct Inc.
23 Snider Way
Sparus, NV 89431
U.S.A.
Phone: (702) 359-4451
Big Three Industries, Inc.
Tempil Division
2910 Hamilton Blvd.
South Plainfield, NJ 07080
U.S.A.
Phone: (201) 757-8300
Telex: 138-662
Illustration 2. Example of temperature detector.