BLOCK 2551933 - Caterpillar

ACTION REQUIRED
See the attached Rework Procedure.SERVICE CLAIM ALLOWANCES
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts Labor Hrs Parts Labor Hrs Parts Labor Hrs
0-3000
0-24 mos 100% 1.0 0 0 0 0
3001-5000
25-36 mos 33.3% 0.5 0 0 50% 0.5
This is a 1.0?hr job.PARTS DISPOSITION
Handle the parts in accordance with your WarrantyBulletin on warranty parts handling.Attach. (1-Rework Procedure) Rework Procedure
Illustration 1
Open the right side engine door.
Remove the 229-9286 Seal to access the fuel tank.
Remove the three 5C-9553 Bolts and 8T-4205 Washersfrom the left side of the fuel sender. The bolts and washers are to bere-used during assembly.
Install one 8T-4133 Nut and one 8T-4815 Rod Endto one end of the 281-5619 Rod (1).
Tighten the nut to a torque of 30 + 3 Nm.
Use one 1B-0676 Pin and one 179-8235 Lock Pinin order to attach the rod assembly to the 279-7127 Bracket (2).
Attach the bracket to the fuel sender using three195-1141 Spacers (3) under the bracket, three 8T-4971 Bolts, and three8T-4205 Washers.
Tighten the bolts to a torque of 6 + 1Nm.
Illustration 2
Install 279-7128 Bracket (1), over the top endof the rod.
10) Install one 8T-4121 Washer and one 8T-0389Locknut (2) to the rod.11) Tighten the locknut until it contacts thebracket, and then tighten one full turn.12) Reinstall the 229-9286 Seal.