BLOCK 2825980 - Caterpillar

Rotate the master light switch fully in the clockwise direction in order to select the WORK position. The master light switch is located to the left of the steering column. The front lamp on the monitor for the work lights will illuminate. This indicates that the headlights are on. All four headlamps (6) can be activated by switching on the high beam headlights. Push the multifunction switch forward in order to activate all four headlights. The multifuction switch is located on the left of the steering column.Press the appropriate symbol in order to activate a group of work lights. Deactivate the work lights by pressing the appropriate symbol again.
Front Side Lamps and Middle Side Lamps - Press switch (1) in order to activate outer lamps (7) at the front of the machine. Switch (1) also activates the lamps (11) that are mounted on the fuel tank.
Rear Lower Lamps - Press switch (2) in order to activate the lamps that are mounted on the fender (8) and the lower lamp (8) .
Rear Upper Lamps - Press switch (3) in order to activate the cab mounted rear lamps (9) .
Front Upper Lamps - Press switch (4) in order to activate the cab mounted front lamps (10) .
Panel Dimmer - Use the panel dimmer in order to vary the intensity of the lighting for the instrument console. Press and hold panel dimmer (5) in order to progressively reduce the intensity of the lighting for the instrument console. A change in the intensity of the lighting may take several seconds. The minimum intensity of light will cause the instrument console to cycle back to a full bright setting. The instrument console will then continue to fade. Release the switch when the desired intensity of the light is observed. Pressing the switch momentarily toggles between the full bright setting and the last dim setting. Turn Signals
Illustration 5 g00336918
Move the multifunction switch upward in order to indicate a right turn. Move the multifunction switch in the downward direction in order indicate a left turn.Note: Always return the switch to the centered position once the turn is complete. An alarm will sound if the turn signals are left in the ON position for more than two minutes. The switch does not automatically return to the centered position after a turn.Interior Lights
Illustration 6 g00337292
Two interior lights are used in order to illuminate the interior of the cab. The lights are located at the front corners of the headliner. Each light is equipped with a three-position switch. ON - Slide the switch fully toward the center of the cab.OFF - Slide the switch to the middle position.Open Door - Slide the switch fully away from the center of the cab. The interior lights will illuminate when the door for the cab is in the OPEN position.Hazard Warning Switch
Illustration 7 g00337353
Failure to activate the hazard lights may cause improper indentification of the tractor, resulting in an accident and personal injury. Always