BLOCK 3087373 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     -     Guide Bolt3/8 inch - 16 NC by 10 inch     2    
B     366 034.0     Ratchet Puller     1    
C     366 003.0     Link Bracket     1    Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.Note: Check all O-ring seals for wear or damage. Use new replacement parts, if necessary.
Illustration 1 g00626409
Illustration 2 g00626314
Install Tooling (A) to the transmission case.
Attach Tooling (C), Tooling (B) and a suitable lifting device to power take-off drive (4).
Install the power take-off drive on Tooling (A) and install the power take-off drive. The weight of power take-off drive (4) is approximately 59 kg (130 lb).
Install bolts (5) and remove Tooling (A). Install the remaining two bolts (5) .
Remove Tooling (B) and Tooling (C) .
Illustration 3 g00626312
Install the O-ring seal and connect tube assembly (3) on power take-off drive (4) .
Illustration 4 g00626308
Install cable assembly (2) with bolts (1) .End By:
Install the power take-off drive shaft. Refer to Disassembly and Assembly, "Power Take-Off Drive Shaft - Remove and Install" for the machine that is being serviced.
Install the seat. Refer to Disassembly and Assembly, "Seat - Remove and Install" for the machine that is being serviced.
Install the steering pilot diverter valve. Refer to Disassembly and Assembly, "Steering Pilot Diverter Valve - Remove and Install" for the machine that is being serviced.