AVSPARE.COM
parts catalog

BLOCK-DUMMY 3237595 - Caterpillar



3237595 BLOCK-DUMMY Caterpillar parts BLOCK
Rating:
11
Alternative (cross code) number:
CA3237595
323-7595
3237595
Caterpillar 3237595 BLOCK-DUMMY

Buy BLOCK-DUMMY 3237595 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Machine Configuration
Cat® Electronic Technician (Cat ET) is used to access the configuration screen. Cat ET will guide the user through the procedure. See Troubleshooting, "Service Tools" for more information about the tools used in this procedure.An electronic control module (ECM) must be configured when replaced. The configuration screen is only for machines with an ECM and configuration must be done before a calibration can be started.Check the configuration screen to resolve a component problem. A component problem could be one of the following:
The component is not installed.
The component is installed but a change to the installation is needed to correct a problem.To get to the configuration screen:
Connect the communications adapter and the computer to the diagnostic service tool connector.
Start Cat ET.
Select "File".
Go to "Select ECM".
Choose the desired ECM.
Go to the "Service" Menu.
Select "Configuration".
Click "OK".Certain operations or characteristics can be changed for attachments or preferences.Configure the VIMSTM Outputs
Use Cat ET to configure the VIMSTM outputs.Procedure
Connect a computer with Cat ET to the machine service connector via the communication adapter.
Turn the disconnect key and the keyswitch ON.
Start Cat ET.
Establish communication with the machine.
Illustration 1 g00895412
Select "Service".
Select "Service".
Illustration 2 g00895419
Select "Configuration".
Select "Configuration".
Illustration 3 g06322165
Typical VIMSTM parameters
Select the "Configuration" option of the "Service" menu or press the "F5" key.The "Configuration" screen will be displayed. See Illustration 3.
Select a parameter.
Click the "Change" button on the configuration screen.The change function will display a dialog box.
Illustration 4 g06322172
Click the down arrow on the right-hand side of the dialog box.The available parameter settings will be displayed.
Highlight the new value.
Click the "OK" button.Cat ET will display the following message:
Illustration 5 g06322174
Click the "Yes" button to change the parameter setting or click the "No" button to cancel the parameter setting change.


Parts block Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.