BLOCK AS-JUNCTION 3283585 - Caterpillar

Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.Pressure air can cause personal injury.When using pressure air for cleaning, wear a protective face shield, protective clothing and protective shoes.The maximum air pressure must be below 205 kPa (30 psi) for cleaning purposes.
Walk-Around Inspection
For your own safety and maximum service life of the machine, make a thorough walk-around inspection before mounting the machine to start the engine.Look around and under the machine for such items such as loose bolts, trash build-up, oil or coolant leaks, broken or worn parts. Inspect the condition of the implements and the hydraulic components. 1. Inspect the implements (if equipped) for damage or excessive wear. Repair if damaged.2. Inspect implement cylinders and linkage for damage or excessive wear. Repair if damaged. 3. Inspect and replace lights, broken bulbs and lenses. 4. Inspect and remove any trash build-up in and around the engine.5. Inspect and repair any cooling system or engine component leaks. 6. Inspect the engine precleaner screen for dirt build-up, and clean with pressure air when there is accumulation. 7. Inspect steps and handholds for condition and cleanliness. Repair or clean if necessary. Inspect the Rollover Protective Structure (ROPS) (if equipped) for damage. Tighten any loose bolts. 8. Inspect the hydraulic system for leaks. Inspect the tank, hoses, tubes, plugs, joints and fittings. Correct any leaks.9. Inspect and repair any final drive leaks. Check the oil level if leakage is noticed.10. Be sure covers and guards are firmly in place. Inspect for damage. 11. Inspect operator's compartment for cleanliness and remove all trash.12. Inspect and repair the instrument panel when broken gauges and lights are found.
Always check condition of seat belt and mounting hardware before operating machine. Replace any damaged or worn parts.Replace the seat belt after three years of usage, regardless of appearance.
13. Inspect seat belt mounting hardware for excessive wear and damage. Replace if damaged.Replace the seat belt after three years if usage, regardless of appearance. A date label, to determine the age of the belt, is sewn into each belt.14. Inspect seat belt for worn or frayed webbing. Replace if damaged.15. Inspect seat belt for correct mounting or damage. Keep mounting bolts that hold mounting hooks together secure with clamps in closed position.16. Inspect for worn or damaged buckle or anticreep slide. Replace if damaged or worn.Pre-Start Checks
1. Open the access covers to gain access to the engine compartment and the coolant reservoir. 2. Measure the engine oil level. Maintain the oil level between the ADD and FULL mark on the dipstick. 3. Observe the coolant level in the radiator. Maintain the