BLOCK-SUPPORT 3476327 - Caterpillar

Illustration 6 g00852057
Remove two bolts (11) and the washers.
Illustration 7 g00852063
Remove three bolts (12) and the washers.
Remove two bolts (13) and the washers.
Use two persons in order to remove side panel (14) .
Repeat steps 4 through 16 for the opposite side.
Illustration 8 g00852064
Remove two bolts (15) and the washers.
Place sensor (16) aside.
Illustration 9 g00852066
Disconnect electrical connector (17) .
Illustration 10 g00852069
Disconnect tube assembly (18) .
Disconnect electrical connector (19) .
Illustration 11 g00852071
Cut wire ties (20) .
Illustration 12 g00852073
Remove two bolts (21) and the washers.
Place bracket assembly (22) aside.
Illustration 13 g00852075
Top View
Illustration 14 g00852076
Disconnect electrical connector (23) .
Use two persons in order to remove firewall (24) .
Illustration 15 g00852077
Remove three bolts (25) and the washers from front lower panel (26) .
Illustration 16 g00753748
Attach Tooling (B) to the hood and engine enclosure, as shown.
Attach a suitable hoist and lifting chains to Tooling (B), as shown.
Illustration 17 g00852079
Remove two bolts (27) and the washers. Repeat this procedure for the opposite side.
Illustration 18 g00852081
Remove upper rear mounting bolt (28) and the washer. Repeat this procedure for the opposite side.
Illustration 19 g00852085
Remove two bolts (29) and the washers. Repeat this procedure for the opposite side.
Illustration 20 g00852090
Use the hoist in order to remove hood and engine enclosure (30). The weight of hood and engine enclosure (30) is 230 kg (500 lb).