BLOCK 3657714 - Caterpillar

To prevent personal injury and/or equipment damage from failed lines or components while the hydraulic test equipment is returned to the open flow position, slowly open the hydraulic test equipment valve while monitoring the pump flow.If pump flow does not increase as the valve is opened, shut the engine off and determine what is preventing the pump from upstroking.
Start the engine.
Increase the hydraulic oil temperature to 55° 5°C (131° 9°F).
Illustration 9 g01432992
Monitor (A) Display (B) Keypad (C) Up key (D) Left key (E) Down key (F) Right key (G) Cancel key (H) Home key (I) OK key (J) Menu key
Start Service Mode and input a fixed power shift pressure of 2350 kPa (340 psi).
Press menu key (J) .Note: If more than thirty seconds pass between pushing the keys on the keypad, the menu mode will be cancelled and the previous display will be restored to message display (A) .
Press right key (F) in order to highlight "SERVICE" menu option.
After the "SERVICE" option is highlighted, press OK key (I) .
Illustration 10 g01358403
After OK key (I) is pressed, the screen in Illustration 10 will be displayed. The password for the service menu is "FFF2". The keys for direction are used to input the password. Press left key (D) or right key (F) in order to change the position of the flashing character. Press OK key (I) in order to enter the highlighted character.
After entering the last letter of the password, the monitor will continue with the "SERVICE" screen.
Repeatedly press down key (E) in order to highlight the "DEVICE TEST" line on the display.
After the "DEVICE TEST" line is highlighted, press OK key (I) .
Once the "DEVICE TEST" screen is displayed, press down key (E) until "POWER SHIFT PRES" appears on the display.
When "POWER SHIFT PRES" is highlighted, press OK key (I) .
Place the machine controls at the following settings: engine speed dial "10" and AEC switch OFF. Refer to Testing and Adjusting, "Engine Performance - Test (Engine Speed)" for engine rpm settings.Note: Press OK key (I) within 5 seconds after completion of Step 3.j in order to ensure high idle.
The "POWER SHIFT PRES" will now be displayed. Line 4 of the display will now change to a numeric value. These characters represent the power shift pressure (kPa).
Press left key (D) or right key (F) in order to increase or decrease the numeric value that is displayed on line 4 of the display. Pressing left key (D) decreases the power shift pressure. Pressing right key (F) increases the power shift pressure.Note: The value for power shift pressure on the monitor may not always match the pressure reading on the pressure gauge. Adjust the value on the monitor until the desired power shift pressure is attained on the pressure gauge that is connected to the pressure tap for power shift pressure. The actual power shift pressure must be 2350 kPa (340 psi) on the pressure gauge.Note: To prevent a change in power shift pressure during the main pump flow test, do not