BLOCK 3709352 - Caterpillar

Introduction
Use the following procedure in order to measure the case drain of the travel motors.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Required Tools
Illustration 1 g02148680
Tooling group "D"
Illustration 2 g03269576
Table 2
Tool Item Qty Part Number Description
D D1 1 6V-7788 Flow Meter
5 to 60 L/min (2 to 15 US gpm)
D2 1 8C-6874 Connector
D3 2 6V-9746 O-Ring Seal
D4 1 124-1921 Permanent Coupling
D5 1 122-6872 Bulk Hydraulic Hose
D6 1 124-2153 Permanent Coupling
F 1 311-1362 Vacuum Cap
G 1 418-3612 Track Block Machine Preparation
Position the machine on level ground.
Illustration 3 g03369590
Sprocket (forward left travel)
(G) Track Block
(1) Sprocket
Place track block (G) in sprocket (1) in order to block forward left travel. Refer to Illustration 3.
Stop the engine.
Release the pressure in the hydraulic system. Refer to Testing and Adjusting, "System Pressure - Release".
Attach 311-1362 Vacuum Cap onto the hydraulic tank. Attach an air supply hose onto the assembly. Apply 276 to 414 kPa (40 to 60 psi). This procedure will pull a vacuum on the hydraulic system.
Illustration 4 g02144928
Flow Meter Tool Layout
(2) Case drain hose
(3) Elbow
(4) Travel motor
(D1) Flow meter
(D2) Connector
(D3) O-Ring seal
(D4) Permanent coupling
(D5) Hose
(D6) Permanent Coupling
Install the following tools in accordance with the flow meter tool layout. Refer to Illustration 4.
Disconnect case drain hose (2) from elbow (3).
Connect the flow meter assembly (D) between elbow (3) and case drain hose (2). Note: Correct orientation of the flow meter is necessary. The oil flows from travel motor (4) to case drain hose (2).
Remove 311-1362 Vacuum Cap. Test Procedure
Start the engine.
Increase the hydraulic oil temperature to 55° 5°C (131° 9°F).
Place the hydraulic activation control lever in the UNLOCKED position.
Set the engine speed dial to position "10" and AEC switch "OFF".
Move the left travel lever to full FORWARD position and check the flow of oil through the flow meter. Refer to Table 1.
Remove track block (G) from sprocket (1).
Move the left travel lever in order to reposition the travel motor.
Place track block (G) in sprocket (1) in order to block forward left travel.
Repeat Steps 5 through 8 in order to obtain three measurements of case drain oil.