BLOCK 5N8672 - Caterpillar

Adjusting the Moldboard
To the Right
1. Sideshift the blade to the right. 2. Lower the blade to the ground. 3. Loosen the bolts securing the cylinder rod end bracket to the moldboard. Remove the bolts and lockwashers.4. Retract the cylinder rod.5. Align the bolt holes in the bracket with the alternate holes in the moldboard.6. Install the lockwashers, bolts and tighten the bolts.To the Left
1. Sideshift the blade to the left.2. Lower the blade to the ground.3. Loosen the bolts securing the cylinder rod end bracket to the moldboard. Remove the bolts and lockwashers.4. Extend the cylinder rod.5. Align the bolt holes in the bracket with the alternate holes in the moldboard.6. Install the lockwashers, bolts and tighten the bolts.Scarifier Digging Angle
1. Lower the scarifier to the ground. 2. Remove the bracket bolts on both sides of the scarifier.3. Raise or lower the scarifier to set the angle.4. Install the bracket bolts.Service Light Power Receptacle
Insert service light connector (if equipped) into the receptacle to provide power for the service light.