BODY 1011984 - Caterpillar

Single Axis Levers Kit Location
Illustration 2 g06113704
Illustration 3 g06113708
View of area A
Location of 491-9604 Joystick Control Kit
Kit Installation Procedure
Illustration 4 g06113715
(B) Electrohydraulic control
Remove electrohydraulic control (B) , refer to "Disassembly and Assembly" , Electrohydraulic Control.
Illustration 5 g06113722
(1) 450-5070 Film
(2) 449-4002 Film
(3) 503-6401 Electrohydraulic Control and Mounting Gp
(C) 361-5015 Hydraulic Control Support Gp
Apply film (1) and film (2) on electrohydraulic control and mounting group (3). This step only applies to XE machines with the following prefixes (B8P, P6C, M5S, and EDW).Note: 275-6530 Film will need to be removed and replaced by 450-5070 Film for XE machines with the following prefixes (B8P, P6C, M5S, and EDW).
Install electrohydraulic control (3) to hydraulic control support group (C), refer to "Disassembly and Assembly" , Electrohydraulic Control.
Illustration 6 g06113728
Bottom view of electrohydraulic control and mounting group
(3A) 495-6226 Electrohydraulic Wiring Gp
Illustration 7 g06113733
Back side view of electrohydraulic control and mounting group
(3A) 495-6226 Electrohydraulic Wiring Gp
(C) 361-5015 Hydraulic Control Support Gp
Route electrohydraulic wiring group (3A) through bottom of hydraulic control support group (C) as shown in Illustration 6 and Illustration 7.
Illustration 8 g06113745
(3A) 495-6226 Electrohydraulic Wiring Gp
(D) 487-7395 Operator Controls Harness As
Connect electrohydraulic wiring group (3A) to operator control harness assembly (D).Software Configuration
Note: This machine feature can be configured and must be activated with product software programming system or service tool.
Use Caterpillar Electronic Technician (CAT ET) and select the Transmission Electronic Control Module (ECM).
Select "Service" from the menu.
Select "Configuration" from the menu.
Double-click the desired feature on the "Configuration" screen to change.
Change parameter to specify "joystick not installed" and click "OK". The change will be activated on the next power cycle.Note: A self-test will be performed after every key on power cycle.