BODY AS-PISTON 1014142 - Caterpillar

When performing maintenance above ground level, always use appropriate devices such as ladders and man lift machines.
Illustration 1 g01266485
Squeeze the outlet tube (1) slightly in order to purge the dirt from the outlet tube.
Illustration 2 g01266486
Loosen the cover latches (2) and remove the air cleaner cover.
Illustration 3 g00101415
Remove the primary filter element from the air cleaner housing.
Clean the air cleaner cover and the inside of the air cleaner housing.
Inspect the O-ring seal on the air cleaner cover. Replace the O-ring seal if the O-ring seal is worn or damaged.
Install the clean primary filter. Note: Refer to "Cleaning Primary Air Filter Elements".
Install the air cleaner cover and close the latches securely.
Illustration 4 g00101416Note: Install the air cleaner cover properly. The arrows must point upward.
Change the filter if any of the following conditions occurs:
Restricted Air Filter indicator on the monitor panel still comes on.
Exhaust smoke is still black after the installation of a primary filter.
Close the access door. Cleaning Primary Air Filter Elements
Prentice recommends certified air filter cleaning services available at participating Prentice dealers. The Prentice cleaning process uses proven procedures to assure consistent quality and sufficient filter life.Observe the following guidelines if you attempt to clean the filter element:Do not tap or strike the filter element in order to remove dust.Do not wash the filter element.Use low pressure compressed air in order to remove the dust from the filter element. Air pressure must not exceed 207 kPa (30 psi). Direct the air flow up the pleats and down the pleats from the inside of the filter element. Take extreme care in order to avoid damage to the pleats.Do not use air filters with damaged pleats, gaskets, or seals. Dirt entering the engine will cause damage to engine components.
When the primary air filter element is cleaned, check for rips or tears in the filter material. Replace the primary air filter element after the primary air filter element has been cleaned six times. The primary air filter element should be replaced at least one time per year. This replacement should be performed regardless of the number of cleanings.Visually inspect the primary air filter elements before cleaning. Inspect the air filter elements for damage to the seal, the gaskets, and the outer cover. Discard any damaged air filter elements.There are two common methods that are used to clean primary air filter elements:
Pressurized air
Vacuum cleaningPressurized Air
Pressurized air can be used to clean primary air filter elements that have not been cleaned more than two times. Pressurized air will not remove deposits of carbon and oil. Use filtered, dry air with a maximum pressure of 207 kPa (30 psi).
Illustration 5 g00281692Note: When the primary air filter elements are cleaned, always begin with the clean side (inside) in order to force dirt particles toward the dirty side (outside).Aim the hose so that air flows inside the element along the length of the filter to help prevent damage to the paper pleats. Do not aim the stream of air directly at the primary air filter element. Dirt could be forced further