BODY 1799703 - Caterpillar

Assembly Procedure
Refer to Disassembly and Assembly, "Pump Drive - Assemble" for final adjusting of the pump drive.Cleaning Procedure
Before assembly, ensure that all parts are clean. Also, ensure that all passages are free from debris.
After the pump drive is fully assembled, connect the appropriate hardware in order to power the yoke.
Use SAE 10W oil at 66 °C (150 °F). The oil must meet a minimum cleanliness of the standard ISO 16/13. Supply the oil at 12 L/min (3.2 US gpm). Rotate the yoke at 2067 RPM for 20 minutes.
Check for leaks, abnormal noise, or large debris in the drain port. Take corrective action if any of these problems exist.
After this flushing procedure, the oil that is exiting the pump drive must meet a minimum cleanliness of the standard ISO 16/13. If the drain oil does not meet this requirement, repeat Steps 1 through 5 until the oil meets this requirement.