BODY AS-PISTON 2326557 - Caterpillar

Warning Signs and Labels
There may be several specific safety signs on your engine. Please take the time to familiarize yourslf with the safety signs.Make sure that you can read all safety signs. Clean or replace these if you cannot read the words or see the pictures. When cleaning the labels use a cloth, water and soap. Do not use solvents, gasoline, etc., to clean safety signs. The use of solvents, gasoline, etc., could loosen the sign's adhesive and cause the sign to fall off.You must replace a label if it is damaged, missing or cannot be read. If a label is attached to a part, and that part is replaced, make sure a new label is installed on the replaced part. See Caterpillar for new labels.Do not operate or work on the engine unless you have read and understand the instructions and warnings in this Manual. Failure to follow the instructions or consider the warnings could result in injury or death. Contact Caterpillar for replacement Manuals. Proper care is your responsibility.General Hazard Information
Attach a DO NOT OPERATE or similar warning tag to start switch or controls before performing maintenance or repairing the truck/vehicle engine. These tags, SEHS7332, are available from Caterpillar. Do not allow unauthorized personnel on, around or in the truck/vehicle when maintenance or repair is being performed.* When operating the engine in an enclosed area, vent the exhaust to the outside.* If the engine is not running, do NOT release the secondary or parking brake systems unless the truck/vehicle is blocked or restrained.* Wear a hard hat, protective glasses, hearing protection and other protective equipment as required by job conditions.* Do not wear loose clothing or jewelry that can catch on controls or other parts of the engine.* Make certain all protective guards and covers are secured in place.* Use all cleaning solutions with care.* Never put maintenance fluids into glass containers since glass containers can break.* Report all needed repairs. Unless Instructed Differently, Perform All Maintenance as Follows:* Stop the engine.* Ensure the protective locks or controls are in the applied position.* Apply the secondary (emergency) and/or parking brakes.* Block or restrain the vehicle before performing maintenance or repair.* Disconnect the batteries whenever performing any maintenance or before servicing the electrical system.* Do NOT attempt repairs you do not understand.* Use proper tools; replace or repair broken or damaged equipment.* When starting an engine after repairs have been made to the fuel system or governor, make provisions for shutting off the engine's intake air supply (to stop the engine), in case there is an overspeed on start-up.* Start the engine only from the operator's station (cab). Never short across the starting motor terminals or the batteries as this could bypass the engine neutral-start system as well as damage the electrical system.Pressure Air and Water
Pressure air can cause personal injury. When using pressure air for cleaning, wear a protective face shield, protective clothing and protective shoes. The maximum air pressure must be below 205 kPa (30