BODY AS 2348806 - Caterpillar

Illustration 2 g03424322
The fill cap has been updated to the 368-6468 Transmission Oil Filler Cap Cover (2). The differential dipstick tube is held onto the new tube assembly (1) with clip (3), clip (4), clip (5), bolt (6), hard washer (7), nut (8), and washer (9).
Illustration 3 g03643636
The new 438-5329 Hose As (10) replaces the former 389-6960 Hose As in the 375-0380 Brake Lines Gp. The new hose assembly (10) uses connector (11), O-ring seal (12), and O-ring seal (13) to attach to the new differential fill tube assembly (1). Hose assembly (10) uses connector (29) and O-ring seal (30) to attach to the left-hand wheel.
Illustration 4 g03424324
The new 434-4590 Hose As (14) replaces the former 373-6706 Hose As in the 375-0380 Brake Lines Gp .Note: The new 434-4590 Hose As (14) uses an additional clip point for routing. Weld a boss on the fender for a clip point.
Illustration 5 g03424325
(C) Refer to 6 for detailed view of area C
Illustration 6 g03424337
(D) Dimension is 132 mm (5.2 inch) (E) Dimension is 348 mm (13.7 inch) (W1) 3 mm (0.1 inch) fillet weld on all around the bossBoss (15) is located and welded on the fender as per dimension shown in Illustration 9.
Illustration 7 g03424343
The new hose assembly (14) routes through the new clip point using boss (15), clip (16), bolt (17), and hard washer (7).
Illustration 8 g03424362
As the new hose assembly (14) routes down from the brake cooling oil tank, some additional hardware is used at a clip point in front of the power pack brace. Bracket assembly (18) is attached to the former clip point to raise the hose, holding hose assembly with a clip (16), bolt (17), and a hard washer (7).
Illustration 9 g03424537
(F) Refer to 12 for detailed view of area F (G) Refer to 11 for detailed view of area G (H) Refer to 10 for detailed view of area H
Illustration 10 g03424363
To offset the primary fuel filter drain line (J), bracket assembly (19) mounts to the frame with bolt (20) and spacer (21) on the power pack boss. The existing clip (K) on the drain line is held using bolt (17), and hard washer (7).
Illustration 11 g03424368
The new 439-2181 Hose As (22) replaces the former 389-6960 Hose As in the 349-7322 Fuel Lines Gp .The new hose assembly (22) routes and holds the existing 300-0090 Hose As (L) at two locations. The first clip point uses bolt (23), hard washer (7), spacer (24), and clip (25). The next clip point uses stud (26), two hard washers (7), spacer (29), nut (8), and clip (25). Refer to Illustration 9 for proper orientation and parts location.
Illustration 12 g03424387
At the base of the differential fill tube, a clip point is provided for new hose assembly (22) using clip (3), clip (4), bolt (27), hard washer (7), clip (25), spacer (28), nut (8), and washer (9) .The improved 375-0380 Brake Lines Gp and 349-7322 Fuel Lines Gp are adaptable to machines DBW1-319, LCT1-111 and effective in production with