BODY AS. 2476120 - Caterpillar

Illustration 60 g03417824
Go to "Status" and verify that the data file was pushed "OK". If a push "fail" condition occurs, revisit setting up the VIMS3G Communicator settings and consult local IT support for third party ethernet device settings.
Check the FTP server for verification of data files has been received.Payload Calibration
After software update has been performed and the new ECMs are installed and secured, a payload calibration will be required before returning to service.Payload System - Calibrate
The following information describes the calibration for the truck payload.Note: The TPMS will not operate until a successful payload calibration has been completed.Note: For security, this service program code will only function while Cat ET is connected or the service mode in the Advisor is enabled.
CALIBRATE THE PAYLOAD SYSTEM.
Ensure that the truck body is empty. Carryback weight of the material that is stuck in the truck body can affect the payload measurements.
Operate the empty truck to a minimum ground speed of 4 MPH on hard level ground.
Move the shift control lever to the neutral position and allow the truck to coast to a stop. Do NOT use the service brakes or the retarder.
After the truck stops moving, calibrate the payload system. The Advisor display will show a "Calibration Complete" message, if the calibration was successful.Payload System - Configure
Illustration 61 g01962688
Structure of the "Settings" menuThe following information describes the settings for the "Settings: Payload Config" menu on the truck. The "Settings: Payload Config" menu is located in the "Settings" menu under "VIMS". Refer to the Systems Operation Section, "Settings Menu" to view the structure of the "Settings" menu.Note: In order to configure the settings for the payload, the Advisor must have the Service Mode enabled. Refer to Systems Operation Section, "Service Mode Menu" for instructions to enable the Service Mode.
Illustration 62 g01962469
"Settings: Payload Config" menu"Payload Target Weight"
Navigate to the "Payload" menu From the "Settings" menu. Press the "OK" key to continue.
Press the down button to select the "Payload Target Weight".
Press