AVSPARE.COM
parts catalog

BODY AS 3727597 - Caterpillar



3727597 BODY AS Caterpillar parts 311D LRR BODY
Rating:
70
Alternative (cross code) number:
CA3727597
372-7597
3727597
Caterpillar 3727597 BODY AS
Weight: 66 pounds 29 kg.

Buy BODY AS 3727597 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR,

Compatible equipment models: 3727597:

EXCAVATOR  311D LRR   Caterpillar
Number on catalog scheme: 5
 
  For full view, you need register

Information:

General Information
Starting systems usually have four major components: ... Start switch... Start relay... Starter solenoid... Starter motor
Illustration 1. Typical cranking circuit.The only exception to this typical cranking circuit is that some small engines do not require the start relay. In this case, the start switch is connected directly to the starter solenoid.
Start switches are relatively low current devices. They are rated to switch approximately 5 to 20 amps. Because the coil of a start relay between TP2 (Test Point 2) and TP1 in Illustration 1 draws about 1 amp, the start switch can easily turn on the start relay and have long life.
The switch contacts of a typical start relay are rated to switch between 100 and 300 amps. Because a starter solenoid requires only 5 to 50 amps, the start relay can easily switch this load.
The starter solenoid has two functions: it engages the pinion with the flywheel, and it is a high current switch rated about 1000 amps that actually turns on the starting motor.
The starter solenoid has two coils: the pull-in coil (W) draws about 40 amps and hold-in coil (X) requires about 5 amps. The instant the start relay closes, both coils (W and X) receive power. Battery voltage is applied to the high end of both coils, at Test Point (3) which is the "start" terminal (S). The low end of hold-in coil (X) is permanently connected to the ground post of the starter motor. Grounding for the low end, Test Point (4), of pull-in coil (W) is momentary, and takes place through the DC resistance of the starter motor. When magnetic force builds in both coils, the starter pinion is moved to engage the ring gear. Only then will the solenoid contacts close to power the starter motor. This temporarily removes the ground from pull-in coil (W), and puts battery voltage on both ends of it while the motor cranks. During this period, the pull-in coil is out of the circuit and draws no current. Cranking continues until power to the motor solenoid is turned off by the start switch.
The result of these switches and relays is to permit a 5 amp dash-mounted switch to turn on a 500 to 1000 amp motor for cranking an engine.
Battery voltage (power) available during cranking depends on the temperature of the batteries. See Chart A. This chart is only a GUIDE as to what to expect from a NORMAL system.
Chart B shows maximum allowable voltage drops in the high current battery circuit to the starter. These values are maximums for machines with more than about 2000 SMH. Newer machines have less voltage drops.
Voltage drops greater than those listed are usually caused by loose and/or corroded connections or bad switch contacts.
The entire diagnostic procedure can be reduced to: ... confirming that batteries are within specifications... switches and cables/wiring from the batteries to the starter are not causing too much voltage loss.
The flow chart in Illustration 2 shows the entire procedure.
If the machine is equipped

Caterpillar parts catalog:

Caterpillar parts catalog
311D LRR Excavator CLA00001-UP (MACHINE) POWERED BY C4.2 Engine
311D LRR Excavator DDW00001-UP (MACHINE) POWERED BY C4.2 Engine
311D LRR Excavator LKA00001-UP (MACHINE) POWERED BY C4.2 Engine


Parts body Caterpillar catalog:

3526815 BODY-VALVE
307C, 308E CR, 308E SR, 311C, 311D LRR, 311F LRR, 312C L, 312D, 312D L, 312D2, 312D2 GC, 312E, 312E L, 313D, 313D2, 313D2 LGP, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR, 315C, 315D L, 316E L, 318C, 3...
1768571 BODY
311C, 311D LRR, 312C, 312C L, 312D, 312D L, 314C, 314D CR, 314D LCR
4214384 BODY
311D LRR, 311F LRR, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313D, 313D2, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR
2964700 BODY AS
311D LRR, 312D, 312D L, 313D, 314D CR, 314D LCR, 315D L, 318D L, 319D, 319D L, 319D LN
3783459 BODY
311D LRR, 312D, 312D L, 312D2, 312D2 GC, 312E, 312E L, 313D, 314D CR, 314D LCR, 314E CR, 314E LCR
2983255 BODY
312D, 323D L, 323D LN
3065883 BODY-VALVE
M313D, M315D, M316D, M318D, M318D MH, M322D, M322D MH
6I6905 BODY
319D, 319D L, 319D LN, 320 L, 320B, 320C, 322, 322 FM L, 322 LN, 322B, 322B L, 322B LN, 322C, 323D L, 323D LN, 323D SA, 324D, 324D L, 324D LN, 325, 325B, 325B L, 325C, 325D, 325D L, 329D L, 329D LN, 3...
3640980 BODY
315D L, 316E L, 318D L
3632520 BODY-BREATHER
312E, 312E L, 314E CR, 314E LCR, 316E L, 318E L, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 323E L, 324E, 324E L, 324E LN, 329E, 329E L, 329E LN, 336E, 336E H, 336E HVG, 336E L, 336E LH, 336E LN, 336F ...
3683169 BODY-VALVE
M313D, M315D, M315D 2, M316D, M317D 2, M318D, M318D MH, M322D, M322D MH
7K0615 BODY-COUPLING
115, 315D L, 63, H140CS
2S5011 BODY-FUSE HOLDER
120, 120G, 12E, 12F, 12G, 130G, 140, 14E, 14G, 16, 16G, 235, 315D L, 561D, 571G, 572G, 583K, 594H, 613, 621, 621B, 623, 627, 627B, 631C, 633C, 637D, 641B, 650B, 657B, 666B, 776, 777, 777G, 785D, 834, ...
3783459 BODY
311D LRR, 312D, 312D L, 312D2, 312D2 GC, 312E, 312E L, 313D, 314D CR, 314D LCR, 314E CR, 314E LCR
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.