BODY 3S6040 - Caterpillar

Procedure for the 30-SI
Illustration 16 g00651391
Typical Example
Press collar (31) on rotor (28) .
Slide retainer (30) on rotor (28) .
Press bearing (29) on rotor (28) .
Press housing (22) on rotor (28) and bearing (29) .
Illustration 17 g00651367
Typical Example
Install 4 screws (27) in housing (22) .Note: Do not strike the bearing. Shocks from striking the housing can cause damage.
Install the inner race. Press the bearing into the housing.
Illustration 18 g00651235
Press cap (26) in housing (20). Install the coil and support (24) in housing (20). Guide the field leads through the hole as the coil is installed in the housing. Install 4 screws (25) .
Illustration 19 g00651365
Typical Example
Press stator (23) and housing (20) together. Guide the stator leads through the hole as the stator is installed in housing (20) .
Illustration 20 g00651362
Typical ExampleNote: Do not damage exposed stator windings or field windings. Bumping the windings or scraping the windings may break the insulation. Broken insulation may create a short circuit or a ground.Note: Some models have a fourth mounting lug.
Join housing (22) and housing (20). Install 4 bolts (21).
Illustration 21 g00651234
Install capacitor (34). Install screw (33) .
Illustration 22 g00651233
Install rectifier bridge (32). Install 2 screws (19) .
Illustration 23 g00651232
Slide terminal strap (17) in the housing. Install nut (16). Install screw (18).
Install diode trio (15). Install strap (12) .
Connect 3 leads (14). Install 3 nuts (13) .
Illustration 24 g00651228
Install terminal (11) .
Illustration 25 g00651227
Install regulator (10). Install screw (9) .
Illustration 26 g00651226
Install strap (7). Connect leads (5). Install nut (6). Install screw (8) .
Illustration 27 g00651225
Connect 2 leads (4). Install 2 insulated screws (3).
Illustration 28 g00651125
Position plate (2). Install 4 screws (1) .
Install the fan, the pulley, the washer, and the pulley nut.