BODY 6E3043 - Caterpillar

Introduction
Illustration 1 g06055097
View of single radar configuration
Illustration 2 g06056468
View of dual radar configuration
This special instruction details how to adjust the brackets for the Cat ® Detect on certain Wheel Loaders.Safety
Do not perform any procedure in this Special Instruction until you have read the information and you understand the information.
Move the machine to a smooth, horizontal location that is away from operating machines and away from personal.
Place the transmission in the NEUTRAL position.
Engage the parking brake.
Lower the lift arms to the ground.
Shut off machine.
Set tire pressures to appropriate setting for machine operation.Installation Procedure
Illustration 3 g06009595
Rear view of machine
(A) Cover
Remove cover (A).
Illustration 4 g06009601
View of bracket
(B) Adjustment setting bolts
(C) Hinge bolt
Illustration 5 g06009604
View of bracket
(B) Adjustment setting bolts
(C) Hinge bolt
Remove adjustment setting bolts (B) and loosen hinge bolts (C).
Illustration 6 g06010027
Use a level to plumb the sensor mounting bracket.
Illustration 7 g06010021
Adjust the bracket angle up from plumb rotating to next available hole.Note: If an angle finder is available, target the adjustment to be positive 3 degrees +/- 1.75 degrees from level. For dual radars target the adjustment to positive 1 degree +/-1.75 degrees from level.
Tighten adjustment setting bolts (B) and hinge bolts (C) to 3.7 0.8 N m (33 7 lb in).
Reinstall cover. Torque bolts to 15 3 N m (11 2 lb ft).