BODY 6F0048 - Caterpillar

Installation Procedure
Note: Refer to Specification UENR0995 "Engine Design" for non-specified engine Torque Values.
Illustration 1 g03177762
If necessary, install studs (10) and remove cover (11).
Illustration 2 g03177759
Install the O-ring seal on fuel injection pump and governor (9). Position fuel injection pump and governor (9) onto the flywheel housing.
Install three nuts (8) to fuel injection pump and governor (9). Tighten nuts (8) to a torque of 18 to 20 N m (159 177 lb in).
Illustration 3 g03177783
Apply engine oil to threads and torque fitting (7) to a torque of 16 to 19 N m (12 to 14 lb ft).
Install engine oil pressure sensor (6) and connect the wiring harness assembly. Tighten the engine oil pressure sensor (6) to a torque of 15 to 19 N m (11 to 14 lb ft).
Illustration 4 g02804519
Position bracket (3) and install two nuts (4) and two bolts (5).
Illustration 5 g02804516
Check the timing marks and install the O-ring seal and oil plug cap (1). Install the O-ring seal and cover (2) on flywheel housing (3). End By:
Install the fuel injection lines.