BODY 7M5732 - Caterpillar

Installation Procedure
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.Lubricate the O-ring seals with the lubricant that is being sealed.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01344209
Position control manifold (6) and install bolts (5).
Connect tube assemblies (3). Connect hose assemblies (4) and hose (2). Connect harness assemblies (1).
Fill the hydraulic tank. Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change". End By:
Install floorplates. Refer to Disassembly and Assembly, "Floor Plates - Remove and Install".
Install the center bottom guard. Refer to Disassembly and Assembly, "Bottom Guard - Install".