BODY-RELIEF 8J7396 - Caterpillar

Note: After new lube line is installed check the fluid levels.Rework Procedure - Disassemble
Illustration 2 g03746585
Right side view of machine
Remove 7N-3718 Clip (A) and 358-7193 Tube As (B) from 358-7201 Power Train Oil Lines Gp. Discard all parts. Refer to Illustration 2.
Remove the 6V-8397 O-Ring Seal (E) from the 6V-8723 Elbow (C). Refer to Illustration 2.
Illustration 3 g03746598
Rear view of torque converter housing
Remove 339-0078 Adapter (F), 6V-8724 Elbow (G), 3J-1907 O-Ring Seal (H), and 6V-8397 O-Ring Seal (E). Save adapter (F) and elbow (G) and discard all other parts. Refer to Illustration 3.
Illustration 4 g03746600
Temporary disconnect hose (S) from the torque converter housing. Discard the existing O-ring. Remove 6V-0852 Dust Cap (J), 164-5567 Quick Disconnect Coupler As (K), 165-4931 Elbow As (L), and 9W-1686 Spacer (M). Discard all parts. Refer to Illustration 4 and Illustration 5.Rework Procedure - Assemble
Illustration 5 g03746601
Rear view of torque converter housing
Illustration 6 g03746602
View of area P from Illustration 5
Install new fitting assembly (1), elbow (2), O-ring seal (3), and O-ring seal (4) to spacer (5). Refer to Illustration 6.
Illustration 7 g03810147
Install spacer (5) to torque converter housing using O-ring seal (14) and connect power train hose (S) using new seal (14). Refer to Illustration 7.
Install adapter (F) that was saved in Step 3 with O-ring seal (6) to spacer (5). Assemble 6V-8724 Elbow (G) that was saved in Step 3 using seal (15). Refer to Illustration 7.
Install new hose assembly (8) with new O-ring seal (3) to elbow (G). Refer to Illustration 7.
Illustration 8 g03746603
View of area R from Illustration 5
Secure new hose assembly (8) using two clips (9), two clips (10), two bolts (11), four hard washers (12), and two nuts (13) as shown in Illustration 8.
Illustration 9 g03746606
View of area N from Illustration 5
Install hose (8) to elbow (C) using new seal (3) as shown in Illustration 9.
Secure new hose assembly (8) using clip (9), bolt (11), two hard washers (12), and nut (13) as shown in Illustration 9.
Start the machine and ensure no leaks.Note: After new lube line is installed check the fluid levels.