BODY 9S9676 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00611147
Loosen hose clamp (1) that secures air inlet hose (2) to air inlet elbow (4) .
Disconnect air inlet hose (2) from air inlet elbow (4) .
Remove four bolts (3) and washers that secure the following items to the air inlet manifold: air inlet elbow (4), gasket (5), air inlet heater (6) and gasket (7) .
Illustration 2 g00611165
Remove the following items from the air inlet manifold: air inlet elbow (4), gasket (5), air inlet heater (6) and gasket (7) .Note: Check the condition of the gaskets that are used between the elbow and the air inlet heater. Check the gaskets between the air inlet heater and the air inlet manifold. If the gaskets are damaged in any way, replace the gaskets.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 3 g00611165
Note: Check condition of the gaskets for the air inlet elbow and the air inlet heater. If the gaskets are damaged, use a new part for replacement. The wire mesh gasket (7) is installed between the air inlet manifold and the air inlet heater.
Place the following items in position on the air inlet manifold: gasket (7), the air inlet heater (6), gasket (5) and the air inlet elbow (4) .
Illustration 4 g00611147
Install four bolts (3) that secure the following items to the air inlet manifold: gasket (7), the air inlet heater (6), gasket (5) and the air inlet elbow (4) Tighten bolts (3) to a torque of 28 7 N m (21 5 lb ft).
Connect air inlet hose (2) to air inlet elbow (4) .
Tighten hose clamp (1) that secures the air inlet hose to the air inlet elbow.