BODY-VALVE 9T2656 - Caterpillar

Illustration 2 g00948322
Install bracket (38) and bolt (37) to manifold (9) .
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Illustration 3 g00948352
Install ball (36), spring (35), retainer (34), and retaining ring (33) to spool (29) .
Illustration 4 g00948320
Install O-ring seal (32) to plug (27) .
Illustration 5 g00948319
Install stop (31), spring (30), spool (29), slug (28), and plug (27) to manifold (9) .
Install adjustment screw (26) to manifold (9). Install adjustment screw (26) to the position that was marked during the disassembly procedure.
Illustration 6 g00948317
Install plate (25) and bolts (24) to manifold (9). Tighten bolts (24) to a torque of 48 4 N m (35 3 lb ft).
Install O-ring seal (23) to plug (22) .
Illustration 7 g00948316
Install plug (22) to modulating valve (8) .
Illustration 8 g00948314
Install O-ring seals (21) and (20) to each cartridge (13) .
Illustration 9 g00948313
Install spring (19), spool (18), plug (17), seat (16), ball (15), pin (14), and cartridge (13) to each modulating valve (8) .
Illustration 10 g00948312
Install coil assembly (12), washer (11), and nut (10) to each modulating valve (8). Tighten nut (10) to a torque of 13 2 N m (10 1 lb ft).
Position modulating valves (8) on manifold (9) .
Illustration 11 g00948311
Install bolts (7) to manifold (9). Tighten bolts (7) to a torque of 30 4 N m (22 3 lb ft).
Illustration 12 g00948310
Install O-ring seals (6) to tubes (3) .
Install rubber support (5) to tubes (2) .
Illustration 13 g00948309
Install O-ring seals (4) to tubes (2) .
Install tubes (3) and (2) to the control valve.
Illustration 14 g00948308
Install harness assembly (1) to the control valve.End By: Install the transmission hydraulic control valve. Refer to Disassembly and Assembly, "Transmission Hydraulic Control Valve - Install".