BOGIE AS-FRONT 7G4128 - Caterpillar

Removal Procedure
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01502036
Remove cover (1).
Illustration 2 g01502038
Disconnect harness assemblies (2) and (3).
Illustration 3 g01502040
Disconnect hose assemblies (4).
Illustration 4 g01502042
Disconnect cable assembly (7). Remove bolts (6). Remove the pump and motor (5). Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 5 g01502042
Install the pump and motor (5). Install bolts (6). Connect cable assembly (7).
Illustration 6 g01502040
Connect hose assemblies (4).
Illustration 7 g01502038
Connect harness assemblies (2) and (3).
Illustration 8 g01502036
Install cover (1).