AVSPARE.COM
parts catalog

BOLT 0001604 - Caterpillar



0001604 BOLT Caterpillar parts BOLT
Rating:
11
Alternative (cross code) number:
CA0001604
000-1604
0001604
Caterpillar 0001604 BOLT

Buy BOLT 0001604 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

This machine has been certified to the standards that are listed on the certification plate. The maximum mass of the machine, which includes the operator and the attachments without a payload, should not exceed the mass on the certification plate.Pressurized System (3)Open the access panel on the top of the hood. The safety message is located on the radiator beside the filler cap.
g00817291
Pressurized system: Hot coolant can cause serious burn. To open cap, stop engine, wait until radiator is cool. Then loosen cap slowly to relieve the pressure.
High Pressure Cylinder (Cover) (4)This safety message is located on the top of the valve cover for track adjustment.
g00122899
HIGH PRESSURE CYLINDERDo not remove any parts until all pressure has been relieved to avoid possible personal injury. Relieve pressure by opening relief valve one turn maximum. See maintenance guide for track adjustment procedure.TRACK ADJUSTMENT PROCEDURE
Adjust idler forward to tight track position.
Open relief valve one turn maximum. Adjust idler back 10 mm (.39 inch). Close relief valve.
Refer to Operation and Maintenance Manual, "Track Adjustment - Adjust" for more information.High Pressure Cylinder (Valve) (5)This safety message is located on the top of the track adjustment valve.
g00122900
HIGH PRESSURE CYLINDERDo not remove any parts until all pressure has been relieved to avoid possible personal injury. Relieve pressure by opening relief valve one turn maximum. See maintenance guide for track adjustment procedure.TRACK ADJUSTMENT PROCEDURE
Adjust idler forward to tight track position.
Open relief valve one turn maximum. Adjust idler back 10 mm (.39 inch). Close relief valve.
Refer to Operation and Maintenance Manual, "Track Adjustment - Adjust" for more information.Improper Jumper Cable Connections (6)Open the access door to the battery compartment. The safety message is located on the inside of the access door.
g00122920
Improper jumper cable connections can cause explosion resulting in personal injury.Batteries may be located in separate compartments. When using jumper cables, always connect positive (+) cable to positive (+) terminal of battery connected to starter solenoid and negative (-) cable from external source to starter negative (-) terminal (if machine not equipped with starter negative terminal, connect to engine block.) Follow procedure in the operation manual.
Ether (7)This safety message is located on the cover of the air cleaner inside the engine compartment.
g00924889
If equipped with an air inlet heater (AIH) for cold weather starting, do not use aerosal types of starting aids such as ether. Such use could result in an explosion and personal injury.
High Pressure Cylinder (8)On D5G machines, this safety message is located on the top of the track adjustment valve on each side of the machine.
g00951921
High Pressure Cylinder. Do not remove any parts from the cylinder until all of the pressure has been relieved. This will prevent possible personal injury or death.
Refer to Operation and Maintenance Manual, "Track Adjustment - Adjust" for more information.


Parts bolt Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.