AVSPARE.COM
parts catalog

BOLT( ON PLATFORM GP 0001614 - Caterpillar



0001614 BOLT( ON PLATFORM GP Caterpillar parts 943, 953, D4E BOLT
Rating:
57
Alternative (cross code) number:
CA0001614
000-1614
0001614
Caterpillar 0001614 BOLT( ON PLATFORM GP

Buy BOLT( ON PLATFORM GP 0001614 Caterpillar genuine, new aftermarket tractor parts with delivery
TRACK LOADER, TRACK-TYPE TRACTOR,

Compatible equipment models: 0001614:

TRACK LOADER  943   953  
TRACK-TYPE TRACTOR  D4E   Caterpillar
  For full view, you need register

Information:

Which Generate This Code:The Electronic Control Module (ECM) detects the following condition:
The aftercooler temperature is greater than the default temperature of 102 °C (216 °F) for 5 seconds.
The diagnostic codes 279-03 and 279-04 are not active.System Response:The ECM will log the event. The warning is deactivated if the temperature decreases below 99 °C (210 °F) for 2 seconds.
None
There may be a problem with the aftercooler.
There may be a problem with the aftercooler temperature sensor.Test Step 1. Check for "ACTIVE" Diagnostic Codes.
Start the Caterpillar Electronic Technician (ET).
Turn the main power to the ON position. The engine should be OFF.
Check for any Active Diagnostic Codes or Logged Diagnostic Codes.Expected Result:There should be no diagnostic codes that are present.Results:
OK - There are no diagnostic codes that are present. Proceed to test step 2.
Not OK - There are diagnostic codes that are present.Repair: Repair the diagnostic codes that are present. Refer to the appropriate topic in the "Troubleshooting With a Diagnostic Code" section of this manual. Ensure that the repair eliminates the problem.STOPTest Step 2. Perform a Check of the Cooling System.
Perform a check of the cooling system. Refer to the diagnostic procedure Troubleshooting, "Coolant Temperature is Too High" for possible causes.Expected Result:There are no problems with the cooling system.Results:
OK - There may be an intermittent problem.Repair: Monitor the operation of the engine. Repair the problem. Ensure that the repair eliminates the problem.STOP
Not OK - There is a problem with the cooling system.Repair: Repair the problem. Ensure that the repair eliminates the problem.STOP

Caterpillar parts catalog:

Caterpillar parts catalog
953 TRACK LOADER / HIGH DRIVE / 77Y01093-UP (MACHINE) POWERED BY 3204 ENGINE
943 TRACK LOADER / HIGH DRIVE / 03Y01386-UP (MACHINE) POWERED BY 3204 ENGINE
953 LGP TRACK LOADER 20Z00267-UP (MACHINE) POWERED BY 3204 ENGINE
D4E TRACTOR-SPECIAL APPLICATION / DIRECT DRIVE / 2CB00001-UP (MACHINE) POWERED BY 3304 ENGINE


Parts bolt Caterpillar catalog:

5A3187 BOLT-TRACK (9/16-18 X 3 IN)
931, 931B, 931C, 931C II, 933, 933C, 935C, 935C II, AP-1050, AP-1055D, AP-650B, AP-655D, BG-225C, BG-245C, BG655D, D3, D3B, D3C, D3C II, D3C III, D3G, D3K XL, D3K2 LGP, D4B, D4C, D4C II, D4C III, D4D,...
6V1725 BOLT-TRACK MASTER
578, 583R, 583T, 587R, 587T, D7E, D7E LGP, D7H, D7R, D7R II, D7R XR, D8L, D8N, D8R, D8R II, D8T, PL83, PL87
6V1724 BOLT-TRACK MASTER
578, 583R, 583T, 587R, 587T, D8L, D8N, D8R, D8R II, D8T, PL83, PL87
8T8927 BOLT-BRACKET TO MOUNT
10 FT, 10-20B, 578, 583R, 583T, 587R, 587T, 633E, 651E, 657E, 657G, 8 FT, 8-16B, 824C, 825C, AP-1000B, AP-1055B, AP-1055D, AP-600D, AP-655D, AP-800, AP-800C, AP-800D, AP-900B, AP555E, AS2251, AS2252C,...
3P1111 BOLT-TRACK
D6C, D6D, D6G2 LGP, D6H, D6R, D6R II, D6R III, D6T, D6T LGP, D6T XL, D7G
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.