BOLT 0181349 - Caterpillar

VIEW FROM UNDER CAB1. Remove tube (2) from the machine. Disconnect tubes (1) and (3) from the brake valve.
VIEW FROM UNDER CAB2. Remove cotter pin, nut and bolt (4) from the lever on the end of the steering column. 3. Remove screws, cover (5) from the steering wheel. Remove the three spacers under the cover. 4. Remove nut (6) from the shaft. 5. Install tooling (A) and remove the steering wheel. 6. Remove nut (8) with a 2 1/4 in. open end wrench. Hold the column with a chain wrench if needed. Remove seal (7) from nut (8). 7. Remove nut (9) with tool (B). Remove bearing (10) from the shaft.8. Remove two bolts (12) from the steering column clamp. Remove clamp (11) from the steering column. 9. Move the mat enough to remove bolts (13). Then lower column (14) as far as possible. 10. Remove the wire from bolt (17). Remove bolt (17) and the washer from end of shaft.11. Remove lever (16) with a hammer. Remove the key from the shaft.12. Turn stop (15) off the column. 13. Remove steering column (14) from the cab. Remove shaft (18) from the column. 14. Remove bearing (19) from the bottom of the column (14).Install Steering Column
1. Install the bearing with tooling (A) in the bottom of column (1). 2. Install column (1) in the cab. Install shaft (2) in the column. Lower the column as far as possible. 3. Turn stop (3) on to the column. Install key (4) and lever (5) on the end of the shaft. 4. Install the washer and bolt (6) to the end of the shaft. Install the wire through bolt (6) and around shaft as shown. 5. Lift the column in position and install bolts (7). 6. Install clamp (10) to the bracket. Put bearing (9) in position and install nut (8) with tool (B). 7. Install the seal even with the surface with tooling (A). The lip of the seal is toward the inside of nut (11). 8. Install nut (11) on the column. Tighten the nut with a 2 1/4 in. open end wrench. Hold the column with a chain wrench. 9. Install steering wheel (12) and nut (13) on the shaft. 10. Install spacers (14) on the screws. Install the cover and tighten the screws.
VIEW FROM UNDER CAB11. Connect linkage (15) to the lever with bolt, nut and cotter pin.
VIEW FROM UNDER CAB12. Connect tubes (16) and (17) to the brake valve. Install tube (18) to the brake valve and horn valve.