BOLT 0858091 - Caterpillar

Illustration 1 g02140798
Loosen clamp assemblies (1) and remove hose (2).
Illustration 2 g02140852
Disconnect fittings (3) and (7).
Remove bolts (5), (6), and (8) and remove tube assembly (4).
Remove bolt (9).
Illustration 3 g02140971
Remove nuts (10) and remove bracket (11).
Disconnect harness assemblies (12).
Illustration 4 g02141119
Position harness assembly (13) out of the way. Remove the spacers (not shown) from studs (14).
Illustration 5 g02141131
Remove the bolt (15) and remove the clamp assembly. Discard the clamp assembly.
Remove nuts (23), (19), and (20). Remove the corresponding clamp assemblies and discard the clamp assemblies.
Loosen nuts (16) and (18). Remove fuel line (17) and discard the fuel line. Repeat for the remaining fuel lines.
Loosen nuts (21) and (24). Remove fuel line (22) and discard the fuel line. Installation Procedure
Fuel injection lines MUST only be used once. Discard all fuel injection lines after use.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Make sure that the fuel line caps remain in position until the fuel line is positioned near the corresponding ports in order to prevent contamination. Ensure that the areas around the rail and fuel lines are thoroughly clean before continuing this procedure. If any parts are worn or damaged, use new parts for replacement. Cleanliness is an important factor. Ensure that no debris gets introduced into the fuel system during the installation procedure. If any parts are worn or damaged, use new parts for replacement.
Illustration 6 g02141131
Illustration 7 g02141119Note: Make sure that the fuel line caps remain in position until the fuel line is positioned near the corresponding ports in order to prevent contamination.
Install a new fuel line (17). Hand tighten nuts (16) and (18) on each end of the fuel line. Repeat for the remaining fuel lines.
Install a new fuel line (22). Hand tighten nuts (21) and (24).
Position the clamp assembly and install bolt (15). Hand tighten the bolt.Failure to place the grommet correctly on the fuel line could result in a failed fuel line..
Position the clamp assembly and install nuts (23), (19), and (20). Hand tighten the nuts. Failure to place the grommet correctly on the fuel line could result in a failed fuel line. Note: Ensure that the fuel lines are centered in the nuts prior to tightening. Do not use excessive force or bending in order to assemble the fuel lines.
Tighten nuts (24) and (18) at the fuel rail to a torque of 27 3 N m (239 27 lb in).
Tighten nuts (21) and (16) to a torque of 27 3 N m (239 27 lb in).
Tighten bolt (15) and nuts (23), (19), and (20) to a torque of 12 3 N m (105 27 lb in).
Position the spacers (not shown) and harness (13) onto studs (14).
Illustration 8 g02140971
Install bracket (11) and install nuts (10).
Connect harness assemblies (12).
Illustration 9 g02140852
Position tube assembly (4). Connect fittings (3) and (7). Install bolts (5), (6), and (8).
Install bolt (9).
Illustration 10 g02140798
Position hose (2) and install clamp assemblies (1).
Connect the battery. Refer to Operation and Maintenance Manual, "Battery or Battery Cable - Connect".
Turn the fuel supply