BOLT 025C 0951884 - Caterpillar

Which Generate This Code:This diagnostic code is recorded when the implement ECM has been replaced and all of the solenoid require calibration. This diagnostic code should only appear when the ECM has been replaced.Test Step 1. PERFORM THE CALIBRATION PROCEDURE FOR ALL SOLENOIDS.
Perform the calibration procedure for solenoids. The calibration procedure will cause related diagnostic codes. In the Testing and Adjusting, "Calibration"section, follow the calibration procedure for the blade solenoids. If a ripper is installed, follow the calibration procedure for the ripper solenoids .Expected Result:The solenoids have been calibrated properly. The original diagnostic code is no longer present.Results:
YES - The calibration procedure for each solenoid has been performed successfully. The original diagnostic code is no longer active.STOP
NO - The one or more calibration procedures was not performed successfully.Repair: Perform the procedures again. See Testing and Adjusting, "Calibration".STOP