BOLT 1017537 - Caterpillar

The Machine Will Not Move After You Start The Engine
Table 1
The Machine Will Not Move After You Start The Engine.    
Cause    Solution    
The operation procedure was not performed in the correct sequence.     Move the transmission control to the NEUTRAL position. Then, release the parking brake.    The Inching Operation Is Poor When You Use The Inching Clutch Control
Table 2
The Inching Operation Is Poor When You Use The Inching Clutch Control.    
Cause    Solution    
The transmission directional clutches need to be calibrated.     Calibrate the transmission directional clutches.    The Shifts Are Rough
Table 3
The Shifts Are Rough.    
Cause    Solution    
The transmission directional clutches need to be calibrated.     Calibrate the transmission directional clutches.    The Transmission Will Not Operate
Table 4
The Transmission Will Not Operate.    
Cause    Solution    
There is a displayed fault code. The fault code indicates that the transmission is malfunctioning.     Consult any Caterpillar dealer. (1)    
( 1 ) Caterpillar dealers have the tools and the trained personnel for this service.The Transmission Oil Pressure Is Low
Table 5
The Transmission Oil Pressure Is Low.    
Cause    Solution    
There is not enough oil in the system.     Fill the system with oil.    
The oil supply to the charge pump is restricted or blocked.     Consult any Caterpillar dealer. (1)    
( 1 ) Caterpillar dealers have the tools and the trained personnel for this service.The Shift From 9 To 10 Is Soft Or The Shift From 9 To 10 Is Jerky
Note: The shift from 9 to 10 is typically the harshest shift. The harsh shift is a result of changing from the "F1" clutch to the "F2" clutch. Also, the transmission is changing speed clutches.
Table 6
The Shift From 9 To 10 Is Soft Or The Shift From 9 To 10 Is Jerky.    
Cause    Solution    
The wrong value was entered in the setup.     Change the constant in Mode 10. Consult any Caterpillar dealer. (1)    
( 1 ) Caterpillar dealers have the tools and the trained personnel for this service.The Shift From 8 To 7 Is Soft Or The Shift From 8 To 7 Is Jerky
Table 7
The Shift From 8 to 7 Is Soft or the Shift From 8 to 7 is Jerky.    
Cause    Solution    
The wrong value was entered in the setup.     Change the constant in Mode 10. Consult any Caterpillar dealer. (1)    
( 1 ) Caterpillar dealers have the tools and the trained personnel for this service.