BOLT 1987814 - Caterpillar

CAUTIONThe TecJet 50 contains electrostatic-sensitive components which can be damaged by static electricity from the human body. Before you install the TecJet 50, read the Electrostatic Discharge Awareness precautions on page 1, and discharge the static electricity on your body to ground.
These environmental conditions must be met when installing a TecJet 50:Ambient Operating Temperature
The TecJet 50 must be operated within a temperature range of -20 to +85 °C (-4 to +185 °F), although the TecJet 50 will survive a soak temperature of 105 °C (221 °F) caused by engine shutdown.Storage Temperature
The TecJet 50 must be stored without power applied within a temperature range of -40 to +100 °C (-40 to +212 °F).Gas Temperature
The TecJet 50 requires a regulated gas temperature in the range of 30 - 60 °C (86 - 140 °F).Humidity
The TecJet 50 requires an ambient relative humidity from 0% to 95%, non condensing. The maximum level of relative humidity of the gas that is processed by the valve is 80%.Mechanical Shock and Vibration
The TecJet 50 is designed to withstand vibration and shock according to the following standards:Vibration, Swept Sine, SV3: 5G, 2.5 mm, 5-2000 Hz, 3Hr min/axis, 90 min dwells MS 810C, M514.2, Curve J (Mod)Vibration, Random, RV2: 0.1 G2/Hz, 10-2000 Hz, 3 h/axis, 12.8 Grms MS202F, Method 214A, Test Condition DShock MS1: 40G, 11ms sawtooth Pulse US MIL-STD810C, M516.2, PIElectromagnetic Compatibility
The TecJet 50 complies with the electromagnetic emissions and immunity requirements as specified below:* EN 61000-6-4, Emission Criteria* EN 61000-6-2, Immunity Criteria (see Note) The power for the TecJet 50 must be provided from a protected power source that is compliant with the requirements of EN 61000-6-2. The output of the power source must limit the common mode transients caused by surge transients to less than 50 volts. The I/O cabling for the TecJet 50 should be limited to less than 30 meters in length. The TecJet 50, combined with the power supply and cable limitation, will comply with the requirements of EN 61000-6-2 and allow the system containing the TecJet 50 to be compliant with the EMC Directive.