BOLT 1D4367 - Caterpillar

1D4367 BOLT Caterpillar parts 12E, 7G

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1D4367
1D-4367
1D4367

Buy BOLT 1D4367 Caterpillar genuine, new aftermarket tractor parts with delivery
BULLDOZER, MOTOR GRADER,

Compatible equipment models: 1D4367:

BULLDOZER 7G

MOTOR GRADER 12E Caterpillar

Number on catalog scheme: None

For full view, you need register

Information:

Apply lubricant to the fittings with a hand operated grease gun only. Use of pressure operated lubricating equipment damages the seals.
Illustration 1 g00586840
7H-1680 Lubrication Pump
Illustration 2 g00340074
Remote Fitting
Illustration 3 g00103719
Lubricate the equalizer bar center pin through the remote fitting. The remote fitting is located on the frame on the left side of the machine. The fitting is located below the dipstick.
Illustration 4 g01136376
There are two additional end fittings that are located at each end of the equalizer bar. Clean the areas that are around the end pin with a high pressure wash. Inspect the condition of the seals.Check the area for oil leakage. Be sure that the seal is in a neutral position. Check the oil level. Remove the plug in order to access the grease zerk. Add Caterpillar Gear Oil to the joint through the grease zerk until the air is vented through the passages. When oil is visible in the bottom of the counterbore under plug, the joint is fully lubricated.When you operate the machine in arctic conditions, lubricate the equalizer bar with EMGARD EP 75W90 gear lubricant. EMGARD EP 75W90 gear lubricant is a synthetic lubricant. This lubricant is available from Hudson Corporation.