BOLT 1D4615 - Caterpillar

Electric Power Generation3412 GENSET (S/N: DK61-UP)3512 GEN SET (S/N: ZAF1-UP)3512B GENSET (S/N: ZAH1-UP; ZAJ1-UP)3516B GEN SET (S/N: ZAP1-UP)3516C GEN SET (S/N: SBK1-UP)C175-16 GEN SET (S/N: WYB1-UP)Engine3412C (S/N: RTY1-UP)3512 (S/N: JM21-UP; YBA1-UP; YAK1-UP; 6WW1-UP; YAX1-UP)3512B (S/N: JM31-UP; JM41-UP; YBB1-UP; YBC1-UP; YAM1-UP; YAN1-UP; YAY1-UP; YAZ1-UP)3512C (S/N: YBD1-UP; SBG1-UP; LYP1-UP)3516 (S/N: JCG1-UP; YAL1-UP; ZAL1-UP; ZBL1-UP; YAS1-UP; YBS1-UP)3516B (S/N: JCH1-UP; JCN1-UP; YAP1-UP; ZBP1-UP; PBR1-UP; PDR1-UP; YAR1-UP; ZAR1-UP; ZBR1-UP; GZS1-UP; YAT1-UP; YBT1-UP; YAW1-UP; YBW1-UP)3516C (S/N: SKC1-UP; SBJ1-UP; SCJ1-UP; SFJ1-UP; SCK1-UP; SEK1-UP; SFK1-UP)3516E (S/N: JH81-UP; LCK1-UP)C175-16 (S/N: WYC1-UP)C175-20 (S/N: BXR1-UP)Generator SetC27 GEN SET (S/N: 2A31-UP; GDS1-UP; T4Z1-UP)C32 GEN SET (S/N: AL61-UP; JSJ1-UP; JAZ1-UP)Power ModulePM3512 (S/N: TC81-UP)PM3516 (S/N: KEN1-UP; NBR1-UP)Introduction
Do not perform any procedure in this Special Instruction until you have read the information and you understand the information.Safety Section
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.
Failure to follow all safety guidelines prescribed in this document and by governing authorities and regulatory agencies may result in severe injury or death of personnel or machine damage.
Personal injury or death can result from improper maintenance procedures. To avoid injury or death, follow the procedures exactly as stated below.
Before servicing/performing maintenance on the machine, electrical power must be physically disconnected; battery plugs must be disconnected from the batteries, or the trailing cable must be unplugged, and warning tags and padlocks shall be applied by a certified electrician. Certified electricians shall perform or direct any electrical work, including any energized testing, repair work in controllers, motors, or other approved compartments, and shall insure that all compartments are properly closed and inspected prior to re-energization. All applicable lock out and tag out procedures must be followed.
Do not operate the machine if any guards or covers are missing or inadequately secured. Personnel could be seriously injured or machine damage may occur.
Rework Procedure
Rework Procedure for the 332-1131 Contactor and 351-9037 Contactor
Illustration 1 g06332310
Open the jacket