BOLT 1J6238 - Caterpillar

1J6238 BOLT Caterpillar parts D10, D11N

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1J6238
1J-6238
1J6238

Weight: 0.60 pounds 0 kg.

Information:

GRIP LENGTH 9.525 mm

HEAD HEIGHT 17.93 mm

HEX SIZE 38.1 mm

LENGTH 47.625 mm

MATERIAL Steel 1035 MPa Min Tensile Strength Rc 33-39

THREAD SIZE 1.00-8

Buy BOLT 1J6238 Caterpillar genuine, new aftermarket tractor parts with delivery
TRACK-TYPE TRACTOR,

Compatible equipment models: 1J6238:

TRACK-TYPE TRACTOR D10 D11N Caterpillar

Number on catalog scheme: 6

For full view, you need register

Information:

Introduction
ReferenceTool Operating Manual, NEHS0950, "Using the 270-5051 Amp ATAC Connector Service Kit"ReferenceTool Operating Manual, SEHS9615, "Servicing Deutsch HD, DT, and DRC Style Connectors"This Special Instruction is intended to ensure that the correct part numbers are ordered on certain sensors and connectors.Selecting Replacement Part Numbers
Note: DO NOT CUT the connector from the harness. This will result in a harness that is too short.
Select the correct replacement part number by using the information in Table 1.
Table 1
Current Sensor Replacement Sensor Ampseal Connector Key
161-1703 274-6717 230-4013 1
161-1704 276-6793 230-4013 1
161-1705 274-6719 237-0227 2
Remove DT style connector body from the engine harness using the proper tools and reinsert the wires into the ampseal connector body.
Illustration 1 g01991474
Wire location guide
Use Illustration 1 as a wire location guide.Note: Refer to Tool Operating Manual, SEHS9615, "Servicing Deutsch HD, DT, and DRC Style Connectors" for information on removing the DT connector.Note: Refer to Tool Operating Manual, NEHS0950, "Using the 270-5051 Amp ATAC Connector Service Kit" for information on installing the ampseal connector.
Start the engine and verify the sensor values by using Caterpillar Electronic Technician (Cat ET).