BOLT 1S9810 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 238-9586 Camshaft Drive Group 1
B 1P-0820 Hydraulic Puller 1
8B-7548 Push-Puller Tool Group 1
8B-7559 Adapter 2
5H-1504 Hard Washer 3
9U-6600 Hand Hydraulic Pump 1
C 8T-3168 Pilot Assembly 2
4J-7945 Bolt 2
D 8T-3167 Guide Assembly 1
E 8T-3169 Crank Assembly 1 Start By:
Remove the rocker shaft assemblies and the pushrods.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Remove the engine speed/timing sensor. Refer to Testing and Adjusting, "Engine Speed/Timing Sensor".
Illustration 1 g00579084
Remove access covers (1) from each side of the engine.
Illustration 2 g00579086
Illustration 3 g00579090
Push valve lifters (2) away from the camshaft. Hold valve lifters (2) in position with the O-ring seal.
Illustration 4 g01281295
Remove the bolts and cover (4) from the front housing.
Remove the bolts and cover (3) from the front housing.
Illustration 5 g01281296
Disconnect harness assembly (X) and remove the bolts from cover (5).
Illustration 6 g00579522
Remove cover (6) for the camshaft drive gears from the flywheel housing.
Illustration 7 g00579141
Remove the bolt and plate (7) that fastens camshaft drive gear (8) to the camshaft.
Illustration 8 g00579142
Place the three washers from Tooling (B) behind plate (7) and install the bolt.