BOLT 2080956 - Caterpillar

Installation Instructions
Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact the skin.
Assemble the new oil filter base by performing the following steps:
Illustration 1 g00920544
Install relief valve plungers (18), springs (17), and spacer (27) into oil filter base assembly (20) .
Place gasket (41) and cover (21) into the correct position on the oil filter base assembly. Install bolts (1), bolt (2), and bolt (3) in order to secure the cover.
Install fluid sampling valve (6) with O-ring seal (11) into cover (21). Install dust cap (5) onto the fluid sampling valve.
Install O-ring seal (24) onto the stud at point (C) .
Remove the existing engine oil filter and the filter base from the machine.
Use the following parts in order to install the new filter base onto the machine: two 5P-8118 O-Ring Seals , three 1H-5514 Bolts , one 1D-4540 Bolt and four 9M-1974 Hard Washers .
Illustration 2 g00920879
Position base adapter (22) with O-ring seal (10) over the stud in the oil filter base assembly. Install jam nut (9) onto the stud.Note: Do not tighten jam nut (9) at this time.
Install elbow (35) with O-ring seals (14) and (7) into the base adapter. Install elbow (34) with O-ring seals (14) and (7) into the stud of the oil filter base assembly.Note: Do not tighten elbow (34) or (35) at this time.
Illustration 3 g00920618
View from the left side of the engine (A) Air cleaner
Replace the existing air cleaner bracket with bracket assembly (48) .
Use bolts (32) and three washers (30) in order to assemble base (42) onto the new air cleaner bracket.
Use three bolts (38), two bolts (36), and washers (19) in order to install oil filter base assembly (40) with the seals (8) onto base (42) .
Install adapter (23) with O-ring seal (37) into the top port of base (42). Install elbow (29) into the adapter. Install fluid sampling valve (43) with dust cap (44) into the elbow.
Illustration 4 g00920649
View C-C of Illustration 3
Install spring (15) into bypass valve (4). Install this assembly into the side port of oil filter base assembly (40) .
Install plug (25) with O-ring seal (16) into the port.
Illustration 5 g00931757
Top view of base (42)
Install plug (28) with O-ring seal (12) into base (42) .
Install elbow (34) with O-ring seals (14) and (7) into base (42) .Note: Do not tighten elbow (34) at this time.
Illustration 6 g00931759
Install tube assembly (46). Tighten elbow (34) from the previous step and elbow (34) from Step 5 at this time.
Illustration 7 g00920996
Top view of base (42)
Install connector (33) with O-ring seals (14) and (12) into base (42). Install swivel elbow (39) with O-ring seal (14) into the connector.
Illustration 8 g00921092
Top view of engine
Install tube assembly (45). Tighten elbow (35) from Step 5 and jam nut (9) from Step 4 at this time. Tighten the jam nut to a torque of 149 20 N m (110 15 lb ft).
Remove two of the uppermost bolts that secure the pump drive housing to the flywheel housing. Attach bracket (47) to