BOLT-M14 X 60 2246022 - Caterpillar

Caterpillar® Electronic Technician (Cat® ET)
Illustration 1 g06135476
Connections for the Communication Adapter 3 and Caterpillar® Electronic Technician (Cat® ET)
The components that are needed to use the Communication Adapter 3 and Cat ET 466-6258to determine diagnostic codes are listed:
(1) Current version of Cat ET software
(2) 317-7485 Communication adapter Gp
(3) 457-6114 Datalink Cable
(4) 370-4617Cable Assembly (CA3 PC USB Cable)When using Cat® ET to diagnose machines covered in this manual, cable assembly 457-6114 is required. This harness allows connections between a 9-Pin Port Connector or a 14-Pin Service Port Connector with ethernet and the Communication Adapter 3 module.The new 14-Pin Service Port Connector is designed to work with machines that use a 9-pin Service Port Connector. The new 14-Pin Service Port Connector includes an Ethernet port connector which allows for flashing software using Ethernet. These machines require the use of the 14-Pin Service Connector Cable for the CA3 Communication adapter.
Illustration 2 g03890807
(1) 457-6114 Cable AsCaterpillar® Electronic Technician (Cat® ET) is a software program that is used to access data. The service technician will use the Cat ET to perform the maintenance on the vehicle. Some of the options that are available with the Cat ET are:
Diagnosis of problems
Viewing diagnostic trouble codes
Viewing active event codes and logged event codes
View the status of parameters.
Clear active diagnostic trouble codes and clear logged diagnostic trouble codes
Calibrate the machine systems.
Program the ECU (Flash) with the "WINflash" program. Refer toTesting and Adjusting, "Electronic Control Unit - Flash Program".
Print reports.See Troubleshooting, "Determining Diagnostic Trouble Codes". Diagnostic information is accessed with the following drop-down menus:
Active diagnostic trouble codes
Logged diagnostic trouble codesStatus Groups For Cat® ET
Illustration 3 g00912695
Typical Cat® ET screen for parameters
The status groups are lists of machine parameters. The status of the parameters is shown in real time.Indications and System Response
Message
Table 1
OPERATION
Level (Warning Indications) "Operator Action Required" (Possible Result) (1)
"Action Lamp Status" "Action Alarm Status"
1 Amber Lamp
Steady ON OFF No immediate action is required. The system needs attention soon. No damage will occur to the machine. Minor reductions in machine performance may occur.
2 Amber Lamp
Intermittent ON OFF Change machine operation or perform maintenance to the system. Severe damage to components can occur.
2s Amber Lamp
Intermittent ON Steady ON Change machine operation or perform maintenance to the system. Severe damage to components can occur.
3 Amber Lamp
Intermittent ON
Red Lamp
Steady ON Intermittent ON Immediately perform a safe engine shutdown. Injury to the operator or severe damage to components can occur.
Engine speed limited to 1000 RPM
(1) The possible result, if the operator takes no action.