BOLT 3110501 - Caterpillar

Engines: 3606 (S/N: 8RB1-UP) 3608 (S/N: 6MC1-UP) 3612 (S/N: 9RC1-UP) 3616 (S/N: 1PD1-UP)Introduction
This Special Instruction contains general information on the installation and commissioning procedures for the 3600 Diesel Marine Monitoring System (MMS). This Special Instruction is a supplement to the Operation And Maintenance Manual, SEBU7134, "3600 Diesel Marine Monitoring System".Glossary
CB - Circuit BreakerTB - Terminal BlockECS - Engine Control SwitchFCS - Fuel Control SwitchMECP - Marine Engine Control PanelMMS - Marine Monitoring SystemPLC - Programmable Logic ControlPSS - Prelube/Start SwitchRJWDA - Jacket Water Detector Alarm RelayInstallation Drawings
Use the following illustrations for the standard configuration of the Marine Monitoring System (MMS). If the MMS or other engine features have been customized, the location of the Engine Mounted Junction Box and the size of the Marine Engine Control Panel (MECP) may be different.MECP Size And Mounting Holes
Illustration 1 g00454391
(A) These holes are used for lifting the MECP without the mounting brackets.The Recommended Installation Height Of The MECP
Illustration 2 g00454243
The height is determined by the location of the PC display on the MECP.In-line Engine Junction Box Location
Illustration 3 g00454425
(A) Top View (B) Front View (C) Left Side View
Illustration 4 g00467032
(A) Top View (B) Right Side View (C) Front ViewIllustration 3 is for mounting junction box on the left side. The junction box is mounted on the left side on all engines that are serviced on the right side. Illustration 4 is for mounting the junction box on the right side. The junction box is mounted on the right side on all engines that are serviced on the left side.Vee Engine Junction Box Location
Illustration 5 g00454399
(A) Top View (B) Right Side View (C) Front View (02) Reference to the rear face on the crankshaft adapter
Illustration 6 g00466914
(A) Top View (B) Front View (C) Left Side View (02) Reference to the rear face on the crankshaft adapterIllustration 5 is for mounting the junction box on the right side. The junction box is mounted on the right side on all engines that are serviced on the left side. Illustration 6 is for mounting the junction box on the left side. The junction box is mounted on the left side on all engines that are serviced on the right side.Ambient Capabilities
The ventilation system of the engine room must provide enough air in order to dissipate the heat of the Marine Engine Control Panel (MECP). The Marine Engine Control Panel contains the Programmable Logic Control (PLC), the PC Display, and the backup relays. The MECP can withstand an ambient temperature of 50°C (122°F).The MECP meets the requirements of the Unmanned Marine Society's protection system.If the ambient temperature raises above 50°C (122°F), an 157-1946 Air and Temperature Control Group should be added to the engine. A Custom Quote Request should be submitted at the time of ordering for the cooler.Heat Rejection
The Marine Engine Control Panel emits approximately 100 watts of heat.There should be good air flow around the MECP. This will ensure that the components in the MMS will have the optimum lifetime.MECP Enclosure
The MECP enclosure meets the IP65 classification and the