BOLT-SPECIAL 3170960 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1U-8760     Chain Wrench     1    Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires and on all tubes for installation purposes. Plug all lines, all hoses, and all tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Open the engine hood.
Illustration 1 g00842328
Drain water separator bowl (1) into a suitable container.
Turn lock ring (2) counterclockwise in order to remove water separator bowl (1) .
Illustration 2 g00842337
Disconnect two hose assemblies (4) from fuel priming pump assembly (3) .
Disconnect electrical connector (5) .
Illustration 3 g00842339
Cut wire tie (6) .
Remove three bolts (7) and fuel priming pump assembly.
Illustration 4 g00842359
Use Tooling (A) in order to remove primary fuel filter element (8) .Installation Procedure
Illustration 5 g00842339
Install fuel priming pump assembly (3) and three bolts (7) .
Install new wire tie (6) .
Illustration 6 g00842337
Connect electrical connector (5) .
Connect two hose assemblies (4) to fuel priming pump assembly (3) .
Illustration 7 g00843354
Typical example
Install primary fuel filter element (8) .
Illustration 8 g00842328
Turn lock ring (2) clockwise in order to install water separator bowl (1) .
Tighten the drain valve on the water separator bowl.
Prime the fuel system. Refer to Operation and Maintenance Manual, SEBU7459 for the correct procedure.
Close the engine hood.End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".