BOLT-SPECIAL 3J9173 - Caterpillar

OP5 is the option for programming the generator setpoints. The generator setpoints affect the proper operation and serviceability of the engine, and the accuracy of information shown on the display. The setpoints are programmed in the GSC at the factory.The setpoints may require changing when the GSC is moved from one engine to another engine. The setpoints may also require changing in order to satisfy the customer's requirements. The setpoints that are stored in the GSC must match the specified setpoints of the particular generator set. The setpoints are P01 to P24 and the setpoints are programmable. The setpoints are described in the OP5 Setpoints. Refer to Table 1.Procedure For Engine/Generator Programming
Note: Service Mode cannot be entered when the engine control switch (ECS) is in the AUTO position.Note: Any active shutdown fault must be made inactive in order to access service mode. When a shutdown fault is active, a shutdown indicator is FLASHING. To temporarily change a shutdown fault from an active shutdown fault to an inactive shutdown fault, turn the ECS to the OFF/RESET position. To permanently change a shutdown fault from an active shutdown fault to an inactive shutdown fault, the shutdown fault must be no longer occurring. The fault must be corrected and the ECS must be turned to the OFF/RESET position. If the jumper from terminal 6 to terminal 9 is not installed on the ECS, the GSC does not power up in the OFF/RESET position and any active shutdown fault must be corrected before entering service mode.
Turn the ECS to the STOP position in order to shut down the engine. Enter service mode and enter the password. "OP1" is showing on the lower display. For more information, see Systems Operation, "Password Entry OP3".
Press "SCROLL UP" key four times. "OP5" is showing on the lower display.
Press "SELECT" key one time. "P01" is showing on the display. "P01" is followed by the value of the setpoint.
Press the "SCROLL UP" key or the "SCROLL DOWN" key. The next setpoint is showing with the value of the setpoint. Repeat this step until the desired setpoint is showing.
Press the "SELECT" key. The value of the setpoint is flashing.
Press the "SCROLL UP" key or press the "SCROLL DOWN" key in order to adjust the value of the setpoint.Note: Press and hold the appropriate "SCROLL" key in order to rapidly scroll through a large range of values.
Press the "ENTER" key. The value of the setpoint stops flashing. Repeat steps 4, 5, 6, and 7 until all the desired setpoints are adjusted.
Press "EXIT" key. "OP 1" is showing on the lower display.
Press "EXIT" key. The display will return to the normal mode.
Table 1
OP5 Setpoints Generator Programming (1)    
Setpoint    Name    Description    Range Of Value    Factory Default    
P01     Fuel Solenoid Type     Type of fuel system solenoid used on the generator set. All Larne-built generators covered by this maual are ALWAYS programmed as ETR (0), even if the generator has an ETS fuel solenoid.     0