BOLT-TRACK-MASTER 3T8601 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5p-4996     Plug     2    
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Hot engine components can cause injury from burns. Before performing maintenance on the engine, allow the engine and the components to cool.
Illustration 1 g01376054
Illustration 2 g01376064
Disconnect tube assembly (1) . Remove gasket (2) .
Loosen clamp (6) and position tube assembly (1) out of the way.
Disconnect flame detection temperature sensor (3) .
Disconnect cable assembly (4) and disconnect cable assembly (5) .
Illustration 3 g01376088
Remove tube assemblies (7) , tube assembly (8) , tube assembly (9) . Disconnect tube assembly (10) and (11) and plug with Tooling (A) .
Illustration 4 g01375604
Remove nuts (17) and spacers (16) .
Remove combustion head (15) .
Remove gasket (14) and remove tube assembly (13) .
Remove gasket (12) .Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
B     4C-5597     Anti-Seize Compound     -    
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Illustration 5 g01375604
Note: The gaskets are for one time use. Replace with new gaskets upon installation.
Install gasket (12) and install tube assembly (13) .
Install gasket (14) and install combustion head (15) .
Apply Tooling (B) onto the threads of the studs and nuts (17) . Install spacers (16) and nuts (17) . Tighten nuts (17) in a crisscross pattern to a torque of 23 3 N m (17 2 lb ft). Tighten nuts (17) again in a crisscross pattern to a torque of 28 7 N m (21 5 lb ft). Tighten nuts (17) again in a crisscross pattern to a torque of 28 7 N m (21 5 lb ft).
Illustration 6 g01376088
Connect tube assembly (11) . Tighten tube assembly (11) to a torque of 11 3 N m (97 27 lb in).
Connect tube assembly (10) . Tighten tube assembly (10) to a torque of 17 3 N m (150 27 lb in).
Connect tube assembly (9) . Tighten tube assembly (9) to a torque of 16 1.5 N m (142 132 lb in).
Connect tube assembly (8) . Tighten tube