BOLT-ADJUSTMENT 4396430 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01135604
Attach a suitable lifting device to engine oil cooler (7). The weight of engine oil cooler (7) is approximately 78 kg (172 lb).
Install the O-ring seal on tube (13). Apply clean engine oil to the O-ring seal.
Position engine oil cooler (7) on tube (13). Install bolts (12).
Position the gasket and adapter (11) on the engine oil cooler. Install bolts (6) and bolts (5).
Install the O-ring seal and the retaining ring on tube assembly (10). Install tube assembly (10).
Install the clamp, bolts (8), and bolts (9). Tighten bolts (8) to a torque of 47 9 N m (35 7 lb ft). Tighten bolts (9) to a torque of 47 9 N m (35 7 lb ft).
Illustration 2 g01135600
Install O-ring seals (4) on tube assembly (1). Apply clean engine oil to the O-ring seals.
Install elbow (3) on tube assembly (1). Install tube assembly (1) in the adapter. Position the gasket and elbow (3) on the cylinder block and install bolts (2).
Fill the cooling system. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change". End By:
Install gas pressure regulator.
Install fuel control actuator.