BOLT-HEX HEAD 4731748 - Caterpillar

Stopping the Machine
1. Move the machine to a safe, level location. Use the retarder and service brakes to stop the machine. 2. Move the transmission range selector to NEUTRAL and the transmission neutral lock to ON. 3. Lower the bowl. 4. Move the cushion hitch control to LOCKDOWN. 5. Pull the button out to apply the parking brake. (Earlier machines) move the lever to the PARK position to apply the parking brake. This earlier brake system may not release if the brakes are hot when applied. If the brakes are hot, lower the bowl and block the wheels until they cool.The later system (in step 5), will release properly when the brakes are applied hot.Stopping The Engine
Stopping the engine immediately after it has been working under load, can result in overheating and accelerated wear of the engine components. Follow the stopping procedure outlined below, to allow the engine to cool. This will also prevent excessive temperatures in the turbocharger centerhousing, which would cause oil coking problems.
1. Park the machine and operate the engine at low idle for 5 minutes. 2. Lift the toe of the accelerator to stop the engine. 3. Turn the disconnect switch OFF and remove the key.4. Fill the fuel tank at the end of the shift. This will drive out moisture laden air.5. In freezing weather, drain the air reservoirs.6. When leaving the machine, close and lock the cab door and windows. Lock all vandalism guards and covers in place.