BOLT 5290682 - Caterpillar

Illustration 1 g01119412
Conveyor and propel ECM located on the left side in the large compartment near the radiator. (1) Conveyor ECM mode switch (2) Conveyor display mode switch (3) Conveyor ECM display (4) Conveyor ECMDiagnostic Information
To assist with troubleshooting, the conveyor ECM (4) displays diagnostic information on the ECM display (3). The ECM mode switch (1) is used to select the ECM modes. The display mode switch (2) is used to access information within a given mode. The four types of diagnostic information are discussed below.Operator Error Codes - Conveyor ECM
Certain machine conditions must be present in order for the ECM to operate the conveyor and the augers in AUTO mode. If the machine conditions are not correct, the ECM declares that an operator error exists. When this occurs, the conveyors and augers will not operate in AUTO mode. The conveyor diagnostic lamp will turn ON and the error code will be shown on the ECM display when in mode 0. The operator error code will be preceded by the letter "P". The augers and the conveyors will not operate in AUTO mode until the error code has been cleared. The three different error code identifiers that are for the conveyor system are listed below.P01 - No automatic operation - This operator error is recorded when the conveyor ECM detects that the propel ECM is not in a paving state.P02 - System fault - This operator error is recorded when key switch is ON and the propel ECM is not communicating with the conveyor ECM.P03 - Sonic sensors out of range (if equipped) - This operator error is recorded when the sonic sensors are not properly adjusted. The sensors are too close to the material or too far away from the material.Reference: For more information on troubleshooting the operator error codes, refer to the Diagnostic Code Procedures, "P01, P02 or P03" modules in this manual.Active Diagnostic Codes - Conveyor ECM
When the ECM detects an electrical problem with a component in the conveyor system, the ECM will activate a diagnostic code for the involved component. The conveyor diagnostic lamp located on the operator station panel will turn ON. The lamp notifies the operator that a conveyor system code is active. The active diagnostic code will be displayed on the ECM display when the ECM is in mode 1. The diagnostic codes are shown as "CID FMI" codes. The CID (component identifier) is a three digit number that is associated with a specific component in the conveyor electrical system. The FMI (failure mode identifier) is associated with a specific condition for the component that the ECM detects as an abnormal condition. An FMI code will always be issued with all active CID codes. A troubleshooting procedure is available for all of the diagnostic codes in the conveyor system. Reference: For a complete list of the conveyor system diagnostic codes, refer to the Troubleshooting, "Diagnostic Code List" module in this manual.Reference: For the diagnosttic code troubleshooting procedures, refer to the Troubleshooting, "Diagnostic